53024 SPST SOLID-STATE RELAY Mii HYBRID MICROELECTRONICS PRODUCTS DIVISION Features: Applications: • • • • • • • • • • • • • • Replacement for 690-2 SPST, Normally Open 1000 V RMS Optical Isolation CMOS or TTL Compatible Input Power FET Output – Low On-state Resistance Full Military Temperature Operation: -55ºC to +105ºC Military Environmental Screening Available Built and Tested to MIL-PRF-28750 utilizing the test methods of MIL-STD-883C Qualified to 86001-001 Low level power control Current loop switches Isolated line driver Servo and synchro resolver control Military/Space general purpose switching DESCRIPTION The 53024 is a military SPST solid-state relay. This small, light-weight device is resistant to damage from shock and vibration, and immune to contact-related problems (contamination, arcing) associated with mechanical equivalents. Optical coupling between the input and output stages provides effective isolation up to 1000 volts AC RMS. Power FET outputs eliminate bipolar offset, and minimize output voltage drop. The control logic is TTL and CMOS compatible, and will accommodate bias supplies between 3.8 and 32 VDC. A built-in Schmitt trigger increases noise margin when using the device in the CMOS input mode. This solid-state relay is ideal for use in military systems, or wherever high reliability, low power actuation, and light weight are design considerations. Applications include general purpose signal switching and electronic load control. ABSOLUTE MAXIMUM RATINGS Isolation Voltage ................................................................................................................................................. 1000 VAC RMS Operating Temperature ............................................................................................................................ -55ºC to +105ºC Case Storage Temperature .........................................................................................................................................-55ºC to +125ºC Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement. Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible. MICROPAC INDUSTRIES, INC. HYBRID MICROELECTRONICS PRODUCTS DIVISION • 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281 www.micropac.com E-MAIL: [email protected] 05/18/01 53024 SPST SOLID-STATE RELAY ELECTRICAL CHARACTERISTICS TA = +25ºC PARAMETER Input (Control) Characteristics TTL Configuration Input Current Control Voltage Range Turn-Off Voltage Maximum Turn-On Voltage Minimum Input (Control) Characteristics CMOS Configuration Input Current Control Voltage Range Bias Supply - VC Bias Current Turn-Off Voltage Minimum Turn-On Voltage Maximum Total Schmitt Hysteresis CONDITIONS MIN See Table 1 – Bias Resistance 3.8 TYP MAX UNITS 13 16 32 1.5 mA VDC VDC VDC 25 250 18 32 16 2.8 µA VDC VDC mA VDC VDC VDC 3.8 VC = + 5 VDC See Table 1 – Bias Resistance 2.5 3.8 13 2.5 0.5 1.8 ELECTRICAL CHARACTERISTICS TA = +25ºC PARAMETER Maximum Continuous Operating Output Voltage Maximum Load Current On Resistance – Maximum Typical Thermal Resistance, θJA θJC Turn-On Time, Maximum Turn-Off Time, Maximum Off State Leakage, 80 V Dielectric Strength, Minimum Typical Isolation Resistance CONDITIONS 25ºC 25ºC I/O, 60 Hz Sine Wave Input to Case, 500 V 53024 UNITS 60 1.0 0.35 120 30 3.0 3.0 100 1000 109 VDC A Ohms ºC/W ms ms µA V RMS Ohms Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement. Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible. MICROPAC INDUSTRIES, INC. HYBRID MICROELECTRONICS PRODUCTS DIVISION • 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281 www.micropac.com E-MAIL: [email protected] 05/18/01 53024 SPST SOLID-STATE RELAY Package Dimensions .032 .047 .017 DIA 7 .335 SQ MAX .200 .370 SQ MAX .100 TYP 5 .275 MAX .700 MIN 1 4 3 .100 TYP .085 REF ONLY Application Information TTL CONFIGURATION (NON-INVERTING) CMOS CONFIGURATION (INVERTING) Table 1 Limiting Resistance (RS) Values (With Heat Sink) V(VDC) R(Ω) Rating (W) 3.8-6 6-10 10-14 14-18 18-22 22-26 26-32 300 620 910 1200 1500 2000 ¼ ¼ ½ ½ ½ 1 Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement. Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible. MICROPAC INDUSTRIES, INC. HYBRID MICROELECTRONICS PRODUCTS DIVISION • 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281 www.micropac.com E-MAIL: [email protected] 05/18/01