Preliminary NJM2741 Single Supply Single Operational Amplifier with Full Swing Output ■GENERAL DESCRIPTION The NJM2741 is a low supply voltage operational amplifier with Full swing output. It is suitable for audio section of portable sets, PCs and any General-purpose use. ■PACKAGE OUTLINE NJM2741F ■ FEATURES ●Operating Voltage ●Output Full Swing ●Offset Voltage ●Slew Rate . ●Low Distortion . ●Low Input Voltage Noise ●Bipolar Technology ●Package Outline NJM2741F3 :2.5V to 14V : VOH ≥4.9V Typ. (at V+=5V, RL=5kΩ) : VOL ≤0.1V Typ. (at V+=5V, RL=5kΩ) :1mV Typ : 3.5V/µs Typ. : 0.001% typ. (at V+=5V, f=1kHz) :10nV/√Hz typ. : MTP5, SC88A ■ PIN CONFIGURATION 1 2 5 + − 3 4 PIN FUNCTION 1. +INPUT 2. GND 3. -INPUT 4. OUTPUT + 5. V NJM2741F NJM2741F3 (Top View) Ver.2004-11-26 -1- NJM2741 Preliminary ■ ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL + Supply Voltage Differential Input Voltage Range Common Mode Input Voltage Range V VID VICM Power Dissipation PD Operating Temperature Range Storage Temperature Range Topr Tstg RATINGS UNIT 15 ±15 (Note1) 0 to 15 (Note1) V V V 390[MTP5] (Note2) 280[SC88A] (Note2) mW -40 to +85 -50 to +125 ˚C ˚C (Note1) For supply voltage less than 15V, the absolute maximum input voltage is equal to the supply voltage. (Note2) On the PCB “ EIA/JEDEC (76.2×114.3×1.6mm, two layers, FR-4) “ ■ OPERATING VOLTAGE (Ta=25˚C) PARAMETER RATINGS UNIT 2.5 to 14 V SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT Operating Current I CC R L =∞, V I N =2.5V, No Signal Apply - 2.2 3.3 mA Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain VIO IB IIO AV R S ≤ 10kΩ 65 1 100 5 85 6 350 100 - mV nA nA dB Supply Voltage SYMBOL V + ■ ELECTRICAL CHARACTERISTICS ●DC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER R L ≥10kΩ to 2.5V, Vo=0.5V to 4.5V Common Mode Rejection Ratio Supply Voltage Rejection Ratio Output Voltage CMR SVR VOH VOL 0V ≤ V CM ≤ 4V + + V =2.5V to 14V, V CM =V /2 R L =5kΩ to 2.5V R L =5kΩ to 2.5V 60 60 4.75 - 75 80 4.9 0.1 0.25 dB dB V V Input Common Mode Voltage Range VICM CMR ≥ 60dB 0 - 4 V SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT GB ΦM V NI THD f=10kHz, RL=10kΩ to 2.5V RL=10kΩ to 2.5V, CL=10pF f=1kHz, VCM=2.5V - 10 75 10 0.001 - MHz Deg nV/√Hz % ●AC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER Unity Gain Bandwidth Phase Margin Equivalent Input Noise Voltage Total Harmonic Distortion f=1kHz, AV=+2 RL=10kΩ to 2.5V, Vo=1.5Vrms ●AC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT Slew Rate SR (Note 3), A V =1, V I N =2Vpp R L =10kΩ to 2.5V, C L =10pF - 3.5 - V/µs (Note 3) Number specified is the slower of the positive and negative slew rates. [CAUTION] The specifications on this data book are only given for information, without any guarantee as regards either mistakes or omissions. The application circuits in this data book are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights. -2- Ver.2004-11-26