Preliminary NJM2747 Single Supply Quad Operational Amplifier with Full Swing Output ■GENERAL DESCRIPTION The NJM2747 is a quad low supply voltage operational amplifier with Full swing output. It is suitable for audio section of portable sets, PCs and any General-purpose use. ■ FEATURES ●Operating Voltage ●Output Full Swing ●Offset Voltage ●Slew Rate . ●Low Distortion . ●Low Input Voltage Noise ●Bipolar Technology ●Package Outline :2.5V to 14V : VOH ≥4.9V Typ. (at V+=5V, RL=5kΩ) : VOL ≤0.1V Typ. (at V+=5V, RL=5kΩ) :1mV Typ : 3.5V/µs Typ. : 0.001% typ. (at V+=5V, f=1kHz) :10nV/√Hz typ. ■PACKAGE OUTLINE NJM2747D NJM2747M NJM2747V : DIP14, DMP14, SSOP14 ■ PIN CONFIGURATION 1 2 14 - + + - 13 3 12 4 11 5 10 6 - + + - 7 9 8 PIN FUNCTION 1. A OUTPUT 2. A -INPUT 3. A +INPUT + 4. V 5. B +INPUT 6. B –INPUT 7. B OUTPUT 8. C OUTPUT 9. C -INPUT 10. A +INPUT 11. GND 12. D +INPUT 13. D –INPUT 14. D OUTPUT NJM2747D NJM2747M NJM2747V (Top View) Ver.2004-11-26 -1- NJM2747 Preliminary ■ ABSOLUTE MAXIMUM RATINGS PARAMETER Supply Voltage Differential Input Voltage Range Common Mode Input Voltage Range SYMBOL + V VID VICM Power Dissipation PD Operating Temperature Range Storage Temperature Range Topr Tstg RATINGS UNIT 15 ±15 (Note1) 0 to 15 (Note1) V V V DIP14 (870) DMP14 (450) (Note2) DMP14 (560) (Note3) SSOP14 (420) (Note2) SSOP14 (520) (Note3) -40 to +85 -50 to +125 mW ˚C ˚C (Note1) For supply voltage less than 15V, the absolute maximum input voltage is equal to the supply voltage. (Note2) On the PCB “ EIA/JEDEC (76.2×114.3×1.6mm, two layers, FR-4) “ (Note3) On the PCB “ EIA/JEDEC (76.2×114.3×1.6mm, four layers, FR-4) “ ■ OPERATING VOLTAGE (Ta=25˚C) PARAMETER SYMBOL Supply Voltage V + RATINGS UNIT 2.5 to 14 V ■ ELECTRICAL CHARACTERISTICS ●DC CHARACTERISTICS (V+=5V,Ta=25˚C) SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT Operating Current PARAMETER I CC R L =∞, V I N =2.5V, No Signal Apply - 8 11 mA Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain VIO IB IIO AV R S ≤ 10kΩ 65 1 100 5 85 6 350 100 - mV nA nA dB R L ≥10kΩ to 2.5V, Vo=0.5V to 4.5V Common Mode Rejection Ratio Supply Voltage Rejection Ratio Output Voltage CMR SVR VOH VOL 0V ≤ V CM ≤ 4V + V =2.5V to 14V R L =5kΩ to 2.5V R L =5kΩ to 2.5V 60 60 4.75 - 75 80 4.9 0.1 0.25 dB dB V V Input Common Mode Voltage Range VICM CMR ≥ 60dB 0 - 4 V SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT GB ΦM V NI THD f=10kHz RL=10kΩ, CL=10pF f=1kHz, VCM=2.5V - 10 75 10 0.001 - MHz Deg nV/√Hz % f=1kHz RL=10kΩ to 2.5V, Vo=1.5Vrms - 120 - dB ●AC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER Unity Gain Bandwidth Phase Margin Equivalent Input Noise Voltage Total Harmonic Distortion Amp to Amp Separation CS f=1kHz, AV=+2 RL=10kΩ to 2.5V, Vo=1.5Vrms ●AC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT Slew Rate SR (Note 4), A V =1, V I N =2Vpp R L =10kΩ to 2.5V C L =10pF to 2.5V - 3.5 - V/µs (Note 4) Number specified is the slower of the positive and negative slew rates. -2- Ver.2004-11-26 Preliminary NJM2747 ■ MEMO [CAUTION] The specifications on this data book are only given for information, without any guarantee as regards either mistakes or omissions. The application circuits in this data book are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights. Ver.2004-11-26 -3-