NJU7043 PRELIMINARY Input/Output Full-Swing High Output Current Dual C-MOS Operational Amplifier ■ GENERAL DESCRIPTION The NJU7043 is a dual C-MOS operational amplifier permitting a full-swing input and output in full-swing under high load. Based on C-MOS technology, there are excellent features such as high output current, low current consumption, low operating voltage. ■ FEATURES ● Oprating Voltage ● Input/Output Full-Swing ● High Output Current VDD=1.8 to 5.0V ■ PACKAGE OUTLINE NJU7043D NJU7043M NJU7043V NJU7043RB1 Isourse>40mA typ.at Vo Isink<-40mA typ. at Vo ● Input Offset Voltage VIO=7mV max. ● Wide Input Common Mode Voltage Range VSS to VDD ● Operating Current IDD=700µA typ. ● High Input Impedance 1TΩ typ. ● Low Input Bias Current IIB=1pA typ. ● Ground Sensing ● Tiny Package DIP8, DMP8, SSOP8, TVSP8 ■ PIN CONFIGURATION PIN FUNCTION 1 2 8 - 7 + 3 6 + 4 - 1.OUTPUT1 2.-INPUT1 3.+INPUT1 4.VSS 5.+INPUT2 6.-INPUT2 7.OUTPUT2 8.VDD 5 1 NJU7043 PRELIMINARY ■ ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL Supply Voltage VDD Power Dissipation Operating Temperature Range Storage Temperature Range PD Topr Tstg (Ta=25°C) RATING UNIT 5.5 V 500 (DIP8) 250 (SSOP8) mW 300 (DMP8) 320 (TVSP8) -40 to +85 °C -55 to +125 °C ■ RECOMMENDED OPERATION CONDITION PARAMETER SYMBOL RATING Supply Voltage VDD 1.8 to 5.0 ■ ELECTRICAL CHARACTERISTICS ● DC CHARACTERISTICS PARAMETER SYMBOL Operating Current IDD Input Offset Voltage (Note 1) If the supply voltage (VDD) is less than 5.5V, the input voltage must not over the VDD level through 5.5V is limit specified. (Note 2) Decoupling capacitor should be connected between VDD and VSS due to the stabilized operation for the circuit. (Ta=25°C) UNIT V TEST CONDITION No Signal, Dual Circuits MIN (VDD=3.0V,Ta=25°C) TYP MAX UNIT - 600 1,000 µA VIO - - 7 mV Input Bias Current IB - 1 - pA Input Offset Current IIO - 1 - pA Voltage Gain AV RL=10kΩ 70 90 - dB Common Mode Rejection Ratio CM R 0≤VCM≤1.5V,1.5≤VCM≤3.0V(Note) 45 60 - dB Supply Voltage Rejection Ratio S VR 2.4V ≤ VDD ≤ 5.0V, VCM=VDD/2 70 80 - dB H Level Output Voltage 1 VOH1 RL=10kΩ 2.95 - - V L Level Output Voltage 1 VOL1 RL=10kΩ - - 0.05 V H Level Output Voltage 2 VOH2 RL=600Ω 2.90 - - V L Level Output Voltage 2 VOL2 RL=600Ω - - 0.10 V Input Common Mode Voltage Range VICM CMR>45dB 0 - 3 V (Note) CMR is represented by either CMR+ or CMR- which has lower value. CMR+ is measured with 1.5V≤VCM ≤3V and CMR- is measured with 0V≤ VCM ≤ 1.5V . ● AC CHARACTERISTICS (VDD=3.0V, Ta=25°C) PARAMETER SYMBOL TEST CONDITION MIN TYP MAX UNIT Unity Gain Bandwidth GB RL=10kΩ - 0.8 - MHz Total Harmonic Distortion T HD f=1kHz , Vin=1Vpp,Av=0dB - 0.05 - % Equivalent Input Noise Voltage en f=1kHz - 40 - nV/ √Hz ● TRANSIENT CHARACTERISTICS PARAMETER Slew Rate SYMBOL SR TEST CONDITION RL=10kΩ MIN - (VDD=3.0V, Ta=25°C) TYP MAX UNIT 0.7 - V/µs [CAUTION] The specifications on this databook are only given for information , without any guarantee as regards either mistakes or omissions. The application circuits in this databook are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights. 2