DC/DC Converter TES 2 Series 2 Watt Features Surface Mount DIL-Package 16 Standard Models Regulated Output Voltage I/O-isolation 1’000 VDC Very low Output Noise Indefinite Short-Circuit Protection High Accuracy of Pin Co-Planarity High Reliability, MTBF >800’000 h Reflow Soldering to CECC 00 802, Issue 2 2 Year Product Warranty The TES 2 converter series is intended for all applications where PCB’s are assembled on an automated SMD production line.The small size DIL-package and the light weight allows easy handling by pick-and-place machines. They offer a 1000 VDC I/O-isolation and internal filters to reduce reflected input ripple current and to guarantee low output noise.This product series provides an economical solution for many cost critical applications in industrial and consumer electronics. Models Ordercode TES 2-0511 TES 2-0512 TES 2-0522 TES 2-0523 TES 2-1211 TES 2-1212 TES 2-1222 TES 2-1223 TES 2-2411 TES 2-2412 TES 2-2422 TES 2-2423 TES 2-4811 TES 2-4812 TES 2-4822 TES 2-4823 www.tracopower.com Input voltage Output voltage Output current max. Efficiency typ. 5 VDC ±10% 5 12 ± 12 ± 15 VDC VDC VDC VDC 400 165 ± 85 ± 65 mA mA mA mA 60 60 60 60 % % % % 12 VDC ±10% 5 12 ± 12 ± 15 VDC VDC VDC VDC 400 165 ± 85 ± 65 mA mA mA mA 60 60 60 60 % % % % 24 VDC ±10% 5 12 ± 12 ± 15 VDC VDC VDC VDC 400 165 ± 85 ± 65 mA mA mA mA 60 60 60 60 % % % % 48 VDC ±10% 5 12 ± 12 ± 15 VDC VDC VDC VDC 400 165 ± 85 ± 65 mA mA mA mA 60 60 60 60 % % % % Page 1 DC/DC Converter TES 2 Series 2 Watt Input Specifications Input current no load /full load 5 12 24 48 Vin Vin Vin Vin models models models models 80 35 17 10 mA mA mA mA / 665 mA typ. / 280 mA typ. / 140 mA typ. / 70 mA typ. Surge voltage (1 sec. max.) 5 12 24 48 Vin Vin Vin Vin models models models models 7.5 15 30 55 VDC VDC VDC VDC max. max. max. max. Reverse voltage protection 500 mA max. Input Filter Pi-Filter Output Specifications Voltage set accuracy ±3% Regulation ± 0.3 % max. – Input variation Vin min. to Vin max. – Load variation 10 – 100 % – single output models – dual output models balanced load ± 0.5 % max. ± 3 % max. Ripple and noise (20 MHz Bandwidth) 50 mVpk-pk max. Temperature coefficient ± 0.02 % / °C Output current limitation >120 % of Iout max., constant current Short circuit protection indefinite (automatic recovery) Capacitive load 470 µF max. 220 µF max. – single output models – dual output models General Specifications Temperature ranges – Operating – Case temperature – Storage – 40 °C ... + 60 °C (no derating) + 95 °C max. – 40 °C ... + 125 °C Derating 2.9% / °C above 60 °C Humidity (non condensing) 95 % rel H max. Reliability, calculated MTBF (MIL-HDBK-217 E) >800’000h @ + 25 °C Isolation voltage Input/Output 1’000VDC Isolation capacity Input/Output 100 pF typ. Isolation resistance Input/Output (500 VDC) > 1‘000 M Ohm Switching frequency 80 KHz typ. (depending on load) All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. www.tracopower.com Page 2 DC/DC Converter TES 2 Series 2 Watt Physical Specifications Case material non conductive black plastic Weight 10 g (0.35 oz) Reflow soldering profile Peak temp. 230°C (10 sec max.) 185°C for 90 sec max. Convection reflow solder process is recommended Outline Dimensions mm (inches) 27.2 (1.07) Seating Plane Detail A 14.8 (0.58) (0.02) 0.5 10.2 (0.402) S 20 11 16.1 (0.63) 18.8 (0.74) Top View 1 10 1.0 2.2 (0.04) (0.09) 2.54 (0.1) 15.24 (0.6) 0 1. 4) ( 0 0. (0.006) 1.3 (0.051) 0.15 0.15 Pin-Out Pin Single Dual 1 –Vin (GND) –Vin (GND) 2 –Vin (GND) –Vin (GND) 8 No function Common 9 No function No function 10 No function –Vout 11 +Vout +Vout 12 No function No function 13 –Vout Common 19 +Vin (Vcc) +Vin (Vcc) 20 +Vin (Vcc) +Vin (Vcc) All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. www.tracopower.com Page 3 DC/DC Converter TES 2 Series 2 Watt Solder Pad Dimensions mm (inches) 22.86 (0.9) 2.2 15.24 (0.6) 2.54 (0.1) 2.54 2.54 (0.1) (0.1) 2.8 (0.11) 20.0 (0.787) (0.09) 1.6 min. (0.06 min.) Specifications can be changed without notice Rev. 10/01 Jenatschstrasse 1 • CH-8002 Zurich • Switzerland Tel. +41-1284 2911 • Fax +41-1201 1168 • e-mail: [email protected] • internet: http://www.tracopower.com Page 4