Revised April 2001 FST16245 16-Bit Bus Switch General Description Features The Fairchild Switch FST16245 provides 16-bits of highspeed CMOS TTL-compatible bus switching. The low On Resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. ■ 4Ω switch connection between two ports. The device is organized as a 16-bit switch. There are two 8-bit switches with separate output enable inputs. When OE is LOW, the switch is ON and Port a is connected to Port B. When OE is HIGH, the switch is OFF and a high impedance state exists between the A and B Ports. ■ Control inputs compatible with TTL level. ■ Minimal propagation delay through the switch. ■ Low lCC. ■ Zero bounce in flow-through mode. Ordering Code: Order Number Package Number Package Description MTD48 48-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide FST16245MTD Devices also available in Tape and Reel. Specify by appending the suffix letter “X” to the ordering code. Connection Diagram Logic Diagram Pin Descriptions Truth Table Pin Name Description Inputs OEn Output Enable Input (Active LOW) OEx A, B 1An, 2An, 3An, 4An Bus A L A Port = B Port H Z 1Bn, 2Bn, 3Bn, 4Bn Bus B NC No Internal Connection © 2001 Fairchild Semiconductor Corporation DS500419 Outputs H = HIGH Voltage Level L = LOW Voltage Level Z = High Impedance www.fairchildsemi.com FST16245 16-Bit Bus Switch April 2001 FST16245 Absolute Maximum Ratings(Note 1) Recommended Operating Conditions (Note 4) Supply Voltage (VCC ) −0.5V to +7.0V DC Switch Voltage (VS) (Note 2) −0.5V to +7.0V Power Supply Operating (VCC) DC Input Voltage (VIN) (Note 3) −0.5V to +7.0V Input Voltage (VIN) 0V to 5.5V 0V to 5.5V DC Input Diode Current (lIK) VIN < 0V −50mA Output Voltage (VOUT) DC Output Current (IOUT) 128mA Input Rise and Fall Time (tr, tf) ±100mA DC VCC/GND Current (ICC/IGND) Storage Temperature Range (TSTG) 4.0V to 5.5V Switch Control Input −65°C to +150 °C 0 ns/V to 5 ns/V Switch I/O 0 ns/V to DC -40 °C to +85 °C Free Air Operating Temperature (TA) Note 1: The “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum rating. The “Recommended Operating Conditions” table will define the conditions for actual device operation. Note 2: VS is the voltage observed/applied at either the A or B Ports across the switch. Note 3: The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. Note 4: Unused control inputs must be held HIGH or LOW. They may not float. DC Electrical Characteristics TA = −40°C to +85°C Symbol Parameter VCC Min Typ (V) Max Units Conditions (Note 5) −1.2 4.5 Clamp Diode Voltage HIGH Level Input Voltage 4.0–5.5 VIL LOW Level Input Voltage 4.0–5.5 0.8 V II Input Leakage Current 5.5 ±1.0 µA 0 ≤ VIN ≤ 5.5V 0 ±10 µA VIN = 5.5V ±1.0 µA 0 ≤ A, B ≤ VCC 7 Ω VIN = 0V, IIN = 64 mA VIN = 0V, IIN = 30 mA IOZ OFF-STATE Leakage Current 5.5 RON Switch On Resistance 4.5 (Note 6) 2.0 V IIN = −18mA VIK VIH V 4 4.5 4 7 Ω 4.5 7 12 Ω VIN = 2.4V, IIN = 15 mA 4.0 11 20 Ω VIN = 2.4V, IIN = 15 mA ICC Quiescent Supply Current 5.5 3 µA VIN = VCC or GND, IOUT = 0 ∆ ICC Increase in ICC per Input 5.5 2.5 mA One Input at 3.4V Other Inputs at VCC or GND Note 5: Typical values are at VCC = 5.0V and T A = +25°C Note 6: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the voltages on the two (A or B) pins. www.fairchildsemi.com 2 TA = −40 °C to +85 °C, Symbol Parameter CL = 50pF, RU = RD = 500Ω VCC = 4.5 – 5.5V Min tPHL, tPLH Propagation Delay Bus-to-Bus (Note 7) tPZH, tPZL Output Enable Time VCC = 4.0V Max 1.0 Min Units Conditions Max 0.25 0.25 ns 5.6 6.1 ns VI = OPEN Figures 1, 2 VI = 7V for tPZL Figures 1, 2 VI = OPEN for tPZH tPHZ, tPLZ Output Disable Time 1.0 Figure Number 5.5 5.9 ns VI = 7V for tPLZ VI = OPEN for tPHZ Figures 1, 2 Note 7: This parameter is guaranteed by design but is not tested. The bus switch contributes no propagation delay other than the RC delay of the typical On Resistance of the switch and the 50pF load capacitance, when driven by an ideal voltage source (zero output impedance). Capacitance Symbol (Note 8) Parameter Typ Max Units Conditions CIN Control Pin Input Capacitance 3 pF VCC = 5.0V, VIN = 0V CI/O Input/Output Capacitance “OFF State” 6 pF VCC, OE = 5.0V, VIN = 0V Note 8: TA = +25°C, f = 1 MHz, Capacitance is characterized but not tested. AC Loading and Waveforms Note: Input driven by 50Ω source terminated in 50Ω Note: C L includes load and stray capacitance Note: Input PRR = 1.0 MHz, tW = 500 ns FIGURE 1. AC Test Circuit FIGURE 2. AC Waveforms 3 www.fairchildsemi.com FST16245 AC Electrical Characteristics FST16245 16-Bit Bus Switch Physical Dimensions inches (millimeters) unless otherwise noted 48-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide Package Number MTD48 Technology Description The Fairchild Switch family derives from and embodies Fairchild’s proven switch technology used for several years in its 74LVX3L384(FST3384) bus switch product. Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. www.fairchildsemi.com www.fairchildsemi.com 4