A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT LED LAMPS 1206 Inner Lens White SMD Chip LED Lamps Part Number: AL-HW433A Package outlines & Re-flow Profile Reflow Temp/Time Soldering iron Basic spec is U 5sec when 260℃. If temperature is higher, time should be shorter (+10℃Æ -1sec ).Power dissipation of iron should be smaller than 15W, and temperatures should be controllable .Surface temperature of the device should be under 230℃ . For Reflow Soldering ITEM MATERIALS Resin (mold) Epoxy Lens color Yellow Diffused Printed circuit board BT Dice InGaN Emitted color White NOTES: 1. All dimensions are in millimeters (inches); 2. Tolerances are ±0.1mm (0.004inch) unless otherwise noted. 3. Soldering terminal may shift in x, y direction. 4. Polarity referring on to the Cathode mark is reversed on the red. 2009/2/20 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT LED LAMPS Part Number: AL-HW433A ELECTRO-OPTICAL CHARACTERISTICS Parameter (TA=25℃) Test Symbol Condition Value Min. Typ. Max. 60 Viewing angle at 50% IV IF=20mA 2θ1/2 Forward voltage IF=20mA VF -- 3.2 4.0 Luminous intensity IF=20mA IV -- 150 Chromaticity Coordinates IF=20mA X -- 0.31 -- Y -- 0.32 -- IFP 100 Peak pulsing current (1/10 duty f=1kHz) Absolute maximum ratings Parameter Unit Deg -- V mcd -mA (TA=25℃) Symbol Value Unit Forward current IF 30 mA Reverse voltage VR 5 V Reverse current IR 10 μA Power Dissipation PD 65 mW Electrostatic Discharge ESD 150 V Operating temperature range Top -30 ~+80 ℃ Storage temperature range Tstg -40 ~+85 ℃ 2009/2/20 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT LED LAMPS Part Number: AL-HW433A Test items and results of reliability ＊Refer to reliability test standard specification for in this line. 2009/2/20 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT LED LAMPS Part Number: AL-HW433A Typical Optical-Electrical Characteristic Curves 2009/2/20 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT LED LAMPS Part Number: AL-HW433A Typical Optical-Electrical Characteristic Curves 2009/2/20