ES1A THRU ES1J SURFACE MOUNT FAST ULTRAFAST RECTIFIER VOLTAGE： ：50 TO 600V CURRENT： ： 1.0A SMA／ ／DO-214AC FEATURE Ideal for surface mount pick and place application Low profile package Built-in strain relief High surge capability High temperature soldering guaranteed 260℃/10sec/at terminals Glass passivated chip Ultrafast recovery time for high efficiency MECHANICAL DATA Terminal：Solder plated, solderable per MIL-STD-750, Method 2026 Case： JEDEC DO-214AC molded plastic body over passivated chip Polarity： Color band denotes cathode Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25℃, unless otherwise stated, for capacitive load, derate current by 20％) Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current 3/8″lead length at TL =110℃ Peak Forward Surge Current 8.3ms single half sine- wave superimposed on rated load Maximum Forward Voltage at rated forward current Maximum DC Reverse Current Ta =25℃ at rated DC blocking voltage Ta =125℃ Maximum Reverse Recovery Time (Note1 ) Typical Junction Capacitance (Note 2) Typical Thermal Resistance (Note 3) Storage and Operating Junction Temperature SYMBOL ES1A ES1B ES1C ES1D ES1G ES1J units Vrrm 50 100 150 200 400 600 V Vrms 35 70 105 140 280 420 V Vdc 50 100 150 200 400 600 V If(av) 1.0 A Ifsm 30.0 A Vf 0.92 1.5 10.0 100.0 Ir Trr 1.25 15 μA μA 25 Cj 18.0 R(jl) 30.0 Tstg, Tj -50 to +150 35 nS pF ℃/W ℃ Note： 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 1 3. Thermal Resistance from Junction to terminal mounted on 5×5mm copper pad area Rev.A1 V www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES ES1A THRU ES1J Rev.A1 www.gulfsemi.com