ES2A-A THRU ES2G-A SURFACE MOUNT FAST ULTRAFAST RECTIFIER VOLTAGE: :50 TO 400V CURRENT: :2.0A SMA/ /DO-214AA FEATURE Ideal for surface mount pick and place application Low profile package Built-in strain relief High surge capability High temperature soldering guaranteed 260℃/10sec/at terminals Glass passivated chip Ultrafast recovery time for high efficiency MECHANICAL DATA Terminal:Solder plated, solderable per MIL-STD-750, Method 2026 Case:JEDEC DO-214AC molded plastic body over passivated chip Polarity:color band denotes cathode Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25℃, unless otherwise stated, for capacitive load, derate current by 20%) SYMBOL ES2A-A ES2B-A ES2C-A ES2D-A ES2G-A units Maximum Recurrent Peak Reverse Voltage Vrrm 50 100 150 200 400 V Maximum RMS Voltage Vrms 35 70 105 140 280 V Maximum DC blocking Voltage Vdc 50 100 150 200 400 V Maximum Average Forward Rectified at TL =100℃ Peak Forward Surge Current 8.3ms single half sine- wave superimposed on rated load Maximum Instantaneous Forward Voltage at rated forward current Maximum DC Reverse Current Ta =25℃ at rated DC blocking voltage Ta =100℃ If(av) 2.0 A Ifsm 50.0 A Vf 0.92 1.25 10.0 350.0 Ir µA Maximum Reverse Recovery Time (Note1 ) Trr Typical Junction Capacitance (Note 2) Cj 18.0 pF Typical Thermal Resistance (Note 3) Rth(ja) Rth(jl) 75.0 20.0 ℃/W Tstg, Tj -55 to +150 ℃ Storage and Operating Junction Temperature 15 V 25 nS Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Units mounted on P.C.B. 5.0×5.0mm(0.013mm thick) land areas Rev.A1 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES ES2A-A THRU ES2G-A Rev.A1 www.gulfsemi.com