GP10T SINTERED GLASS JUNCTION PLASTIC RECTIFIER VOLTAGE:1300V CURRENT: 1.0A FEATURE DO-41\DO-204AL High temperature metallurgically bonded construction Sintered glass cavity free junction Capability of meeting environmental standard of MIL-S-19500 High temperature soldering guaranteed 350°C /10sec/0.375”lead length at 5 lbs tension Operate at Ta =55°C with no thermal run away Typical Ir<0.1µA MECHANICAL DATA Terminal: Plated axial leads solderable per MIL-STD 202E, method 208C Case: Molded with UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: color band denotes cathode Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current 3/8”lead length Peak Forward Surge Current 8.3ms single half sinewave superimposed on rated load Maximum Instantaneous Forward Voltage at 1.0A Maximum full load reverse current full cycle Average at 75°C Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =125°C Typical Reverse Recovery Time (Note 1) Typical Junction Capacitance (Note 2) Typical Thermal Resistance (Note 3) Storage and Operating Junction Temperature SYMBOL GP10T units Vrrm Vrms Vdc 1300 910 1300 V V V If(av) 1.0 A Ifsm 25.0 A Vf 1.3 V Ir(av) 30.0 µA Ir Trr Cj Rth(ja) Tstg, Tj 5.0 50.0 2.0 5.0 55.0 -65 to +150 µA µS PF °C /W °C Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Thermal Resistance from Junction to Ambient at 3/8”lead length, P.C. Board Mounted Rev.A1 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GP10T Rev.A1 www.gulfsemi.com