1.5 GHz SILICON MMIC UPC2713T WIDE-BAND AMPLIFIER GAIN vs. FREQUENCY FEATURES 35 • FREQUENCY RESPONSE: 1.5 GHz • 5 V SINGLE SUPPLY VOLTAGE • SUPER SMALL PACKAGE • TAPE AND REEL PACKAGING OPTION AVAILABLE Gain, GS (dB) • INTERNAL CURRENT REGULATION MINIMIZES GAIN CHANGE OVER TEMPERATURE 30 25 20 0 0.5 1.0 1.5 Frequency, f (GHz) DESCRIPTION The UPC2713T is a Silicon Monolithic integrated circuit manufactured using the NESAT III process. This device is suitable for applications which require high gain and wide-band operation. It is designed for low cost gain stages in cellular radios, GPS receivers, DBS tuners, PCN, and test/measurement equipment. NEC's stringent quality assurance and test procedures ensure the highest reliability and performance. ELECTRICAL CHARACTERISTICS (TA = 25 °C, f = 0.5 GHz, VCC = 5 V) PART NUMBER PACKAGE OUTLINE SYMBOLS PARAMETERS AND CONDITIONS UPC2713T T06 UNITS MIN TYP MAX ICC Circuit Current (no signal) mA 9 12 15 GS Small Signal Gain dB 26 29 33 fU Upper Limit Operating Frequency (The gain at fU is 3 dB down from the gain at 0.1 GHz) GHz 0.9 1.2 ∆GS Gain Flatness, PSAT Saturated Output Power dBm P1dB Output Power at 1dB Compression Point dBm -4 Noise Figure dB 3.2 Input Return Loss dB NF RLIN ±0.8 f = 0.1∼0.8 GHz 4 10 7 4.5 13 RLOUT Output Return Loss dB 6 9 ISOL Isolation dB 35 40 ∆GT Gain -Temperature Coefficient dB/°C RTH Thermal Resistance (Junction to Ambient) °C/W -0.016 200 California Eastern Laboratories UPC2713T ABSOLUTE MAXIMUM RATINGS1 (TA = 25°C) SYMBOLS PARAMETERS UNITS RATINGS VCC Supply Voltage V 6 PIN Input Power dBm +10 PT Power Dissipation mW 2802 TOP Operating Temperature °C -40 to +85 TSTG Storage Temperature °C -55 to +150 RECOMMENDED OPERATING CONDITIONS SYMBOL PARAMETER UNITS MIN TYP MAX V 4.5 5.0 Supply Voltage VCC 5.5 TEST CIRCUIT VCC Notes: 1. Operation in excess of any one of these parameters may result in permanent damage. 2. Mounted on 50 x 50 x 1.6 mm epoxy glass PWB (TA = +85°C). 1000 pF **L C3 1000 nH 6 1 IN 50 Ω C2 C1 50 Ω 4 1000 pF OUT 2, 3, 5 1000 pF TYPICAL PERFORMANCE CURVES (TA = 25°C) CIRCUIT CURRENT vs. TEMPERATURE CIRCUIT CURRENT vs. VOLTAGE 40 35 1.4 30 1.2 25 1.0 20 0.8 15 0.6 10 0.4 5 0.2 5 0 0 0 0 1 2 3 4 5 35 Circuit Current, ICC (mA) Circuit Current, ICC (mA) 40 30 25 20 15 10 -60 6 Supply Voltage, VCC (V) NOISE FIGURE AND INSERTION GAIN vs. FREQUENCY -20 0 20 40 60 80 100 RETURN LOSS vs. FREQUENCY 35 0 VCC = 5.0V VCC = 5.5 V 30 10 VCC = 4.5 V VCC = 5.0 V 8 25 20 6 VCC = 5.5 V NF 15 4 VCC = 4.5 V VCC = 5.0 V 10 Input Return Loss, RLIN (dB) Output Return Loss, RLOUT (dB) Gp Noise Figure, NF (dB) Insertion Power Gain, GP (dB) -40 Operating Temperature, TOP (°C) RLOUT -10 RLIN -20 -30 2 0.1 0.3 1.0 3.0 -40 0.1 Frequency, f (GHz) 0.3 Frequency, f (GHz) 1.0 2.0 UPC2713T TYPICAL PERFORMANCE CURVES (TA = 25° C) POWER vs. FREQUENCY ISOLATION vs. FREQUENCY 10 0 VCC = 5.0V PSAT X -10 Power (dBm) Isolation, ISOL (dB) 5 -20 -30 X 0 -5 P1dB -10 -15 -40 0.1 0.3 1.0 3.0 0 Frequency, f (GHz) 1.5 2.0 OUTPUT POWER vs. INPUT POWER AND TEMPERATURE 10 10 f = 0.5 GHZ 5 Output Power, POUT (dBm) 5 VCC = 5.5 V Output Power, POUT (dBm) 1.0 Frequency, f (GHz) X: Typical SSB Third Order Intercept Point OUTPUT POWER vs. INPUT POWER AND VOLTAGE VCC = 4.5 V 0 VCC = 5.0 V -5 -10 -15 TA = 85˚ C VCC = 5.0 V f = 0.5 GHZ TA = -40 ˚C 0 TA = 25˚ C -5 TA = 25˚ C -10 TA = -40 ˚C -15 TA = 85˚ C -20 -20 -25 -25 -60 -50 -40 -30 -20 -10 0 10 NOISE FIGURE vs. FREQUENCY 6 5 4 3 2 0 0.5 1.0 Frequency, f (GHz) -60 -50 -40 -30 -20 -10 Input Power, PIN (dBm) Input Power, PIN (dBm) Noise Figure, NF (dB) 0.5 1.5 0 10 UPC2713T TYPICAL SCATTERING PARAMETERS (TA = 25° C) UPC2713T VCC = 5 V, ICC = 12 mA FREQUENCY (GHz) 0.10 0.20 0.30 0.40 0.50 0.60 0.70 0.80 0.90 1.00 1.10 1.20 1.30 1.40 1.50 1.60 1.70 1.80 1.90 2.00 S11 MAG 0.350 0.290 0.243 0.207 0.185 0.176 0.161 0.148 0.127 0.111 0.097 0.095 0.098 0.110 0.129 0.145 0.161 0.179 0.191 0.197 S21 ANG -21.8 -33.1 -41.7 -47.3 -50.5 -54.0 -57.5 -60.2 -63.9 -62.9 -56.5 -48.2 -40.1 -35.7 -34.6 -36.2 -40.0 -44.7 -50.3 -56.1 MAG 21.9 22.0 22.1 22.3 22.4 22.6 22.8 22.9 22.8 22.3 21.6 20.6 18.9 17.6 15.6 14.2 12.6 11.4 10.2 9.3 ANG -8.1 -25.3 -37.3 -48.6 -60.0 -72.7 -85.7 -100.7 -114.8 -132.0 -147.6 -163.1 -177.8 168.3 154.8 142.7 130.5 120.9 110.1 100.8 Note: 1. K factor calculations: 2 2 2 K = 1 + | ∆ | - |S11| - |S22| , ∆ = S11 S22 - S21 S12 2 |S12 S21| S22 S12 MAG 0.006 0.006 0.007 0.007 0.007 0.008 0.008 0.009 0.009 0.009 0.010 0.010 0.010 0.010 0.011 0.012 0.013 0.014 0.015 0.016 ANG 25.6 24.9 23.7 22.4 21.6 20.1 19.0 18.3 17.2 16.4 15.7 14.4 13.1 12.0 11.8 11.2 10.8 9.8 7.5 5.5 MAG 0.286 0.298 0.313 0.327 0.336 0.348 0.359 0.366 0.366 0.359 0.343 0.320 0.291 0.263 0.234 0.208 0.185 0.164 0.148 0.137 ANG -10.3 -16.1 -25.6 -35.2 -45.4 -56.9 -69.0 -82.9 -96.8 -111.8 -126.8 -142.3 -156.6 -171.7 174.3 160.8 147.1 132.6 119.5 107.4 K1 3.07 3.17 2.77 2.78 2.78 2.41 2.39 2.13 2.15 2.23 2.12 2.24 2.47 2.68 2.77 2.81 2.92 3.02 3.15 3.23 S21 (dB) 26.8 26.9 26.9 27.0 27.0 27.1 27.1 27.2 27.2 27.0 26.7 26.3 25.5 24.9 23.9 23.0 22.0 21.1 20.1 19.4 UPC2713T EQUIVALENT CIRCUIT ORDERING INFORMATION PART NUMBER QTY UPC2713T-E3 3K/Reel VCC Embossed Tape, 8 mm wide. OUT IN LEAD CONNECTIONS (Top View) C1J 3 GND 2 PACKAGE OUTLINE (Units in mm) 1 PACKAGE OUTLINE T06 1. INPUT 2. GND 3. GND +0.2 2.8 -0.3 (Bottom View) 4 4 3 5 5 2 6 6 1 4. OUTPUT 5. GND 6. VCC +0.2 1.5 -0.1 3 0.95 4 1.9±0.2 2 0.95 5 1 6 2.9±0.2 +0.2 1.1 -0.1 -0.05 0.3 +0.10 RECOMMENDED P.C.B. LAYOUT (Units in mm) 3.10 0.13±0.1 0.8 0 to 0.1 Note: All dimensions are typical unless otherwise noted. 3 4 2 5 1 6 0.5 MIN 1.0 MIN EXCLUSIVE NORTH AMERICAN AGENT FOR 0.95 1.0 MIN RF, MICROWAVE & OPTOELECTRONIC SEMICONDUCTORS CALIFORNIA EASTERN LABORATORIES • Headquarters • 4590 Patrick Henry Drive • Santa Clara, CA 95054-1817 • (408) 988-3500 • Telex 34-6393 • FAX (408) 988-0279 24-Hour Fax-On-Demand: 800-390-3232 (U.S. and Canada only) • Internet: http://WWW.CEL.COM DATA SUBJECT TO CHANGE WITHOUT NOTICE 8/02/2000