SPECIFICATION CONTROL DRAWING Product Revision Product Name D-103-33 D-103-34 D-103-35 D-103-36 L max M N M M 20.5 (0.805) ‘XY’ = WIRE GAUGE (AWG) Product Dimensions øA øB K min min min 7.00 (0.275) 7.60 (0.300) AWG 150 (5.900) øD max 22 22 20 20 7.00 (0.275) Cable Dimensions øE J±0.5 min (J±0.02) 3.56 (0.140) 7.00 (0.275) Color of Item 4 black white black white MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked polyvinylidene fluoride. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Sn63 per ANSI-J-STD-006. FLUX: TYPE ROL1 per ANSI-J-STD-004. THERMAL INDICATOR: red. 3. MELTABLE RINGS: Thermally stabilized thermoplastic. Color:gray. 4. GROUND LEAD: Raychem 55A0111-XY in accordance with MIL-W-22759/32 AWG ‘XY’ (see table) stranded tin plated copper. Color: see table. APPLICATION 1. These parts are designed to provide an environment protected shield termination on cables, rated for 125°C minimum, meeting the dimensional criteria listed, having a tin or silverplated copper shields. 2. Temperature range: -55°C to +150°C. Install using Raychem-approved convection or infrared heating tools in accordance with Raychem process standard RCPS-100-70. For best results, prepare the cable as shown: * A trademark of Raychem Corporation. Raychem THERMOFIT DEVICES Raychem Corporation 300 Constitution Drive Menlo Park, CA 94025 USA UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS. INCHES DIMENSIONS ARE BETWEEN BRACKETS. Raychem reserves the right to amend this ANGLES: N/A TOLERANCES: drawing at any time. Users should evaluate 0.00 N/A the suitability of the product for their ROUGHNESS IN 0.0 N/A application. MICRON 0 N/A TITLE: SOLDERSLEEVE* DEVICE WITH PRE-INSTALLED LEAD DOCUMENT NO.: D-103-3X DCR NUMBER: REPLACES: D981005 DRAWN BY: DATE: PROD. REV. DOC ISSUE: M. FORONDA 06/15/98 SEE TABLE 5 If this document is printed it becomes uncontrolled. Check for the latest revision. SCALE: None D1033X SIZE: A SHEET: 1 of 1