Model 4787 & Assembly Instructions “N” Male Cable Plug FEATURES: • Cable connection for RG 58 and 142, 223, 141 MATERIALS: Body and Fitting – Brass per QQ-B-626, Alloy 360, ½ Hard Center Contact – Gold Plated Brass per QQ-B-626, Alloy 360, ½ Hard Dielectric – PTFE Gaskets and Seals: Silicone Rubber Finish: Body and Fittings: Tarnish resistant Center Contact: Gold flash over silver plate per QQ-S-365 RATINGS: Nominal Impedance: 50 Ohms Dielectric Withstanding Voltage: 2500 VRMS, 1 Min., 60 Hz. ORDERING INFORMATION: Model 4787 All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 5/21/02 SY/EH/LS Last saved by PN Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering\Release\DataSheets\FlukeDataSheet \d_AI_4787_2_02.doc PomonaACCESS 90103 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 1 of 2 Model 4787 & Assembly Instructions “N” Male Cable Plug FIGURE #1 A. Slide clamp nut, flat washer and Vee gasket over cable. B. Strip cable jacket to dimensions shown. FIGURE #1A C. Slide braid clamp over braid positioned with the inner shoulder against the cable jacket D. Fold braid over braid clamp. E. Strip Dielectric FIGURE #2 F. Solder center contact to cable center conductor. FIGURE #3 G. Slide clamp nut, flat washer and Vee gasket forward against braid clamp. A. Place connector body over end of cable, thread clamp nut into body and tighten. All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 5/21/02 SY/EH/LS Last saved by PN Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering\Release\DataSheets\FlukeDataSheet \d_AI_4787_2_02.doc PomonaACCESS 90103 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 2 of 2