Model 5285 & Assembly Instructions Cable Plug, BNC Male, Crimp On R658C FEATURES: • Connector accepts types 58, 58C, 58A, 141, 141A MATERIALS: Body and fittings - Brass Center Contact - Brass Outer Contact – Beryllium Copper Gasket – Silicone rubber Dielectric – Teflon Finish: Body and Fittings – Tarnish Resistant Center Contact – Gold plated Outer contact – Tarnish Resistant Marking: “POMONA ELECT. 5285” located approximately as shown. RATINGS: Operating Voltage: 500 VRMS Max. Nominal Impedance: 50 Ohms ORDERING INFORMATION: Model 5285 All dimensions are in inches and metric. All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 5/21/02 SY/EH/LS Last saved by PN Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering\Release\DataSheets\FlukeDataSheet \d_AI_5285_2_02.doc PomonaACCESS 90117 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 1 of 2 Model 5285 & Assembly Instructions Cable Plug, BNC Male, Crimp On R658C FIGURE #1 A. Strip cable as shown. FIGURE #2 B. Fit the center contact over conductor wires, slide until it butts against the dielectric. Crimp or solder. FIGURE #3 C. Slide the metal crimp sleeve over cable, then install the connector body until contact locks into connector. D. Verify that the knurled ferrule of connector is inserted between the dielectric and the braid. FIGURE #4 E. Slide the metal sleeve along the cable unit until it butts against the bottom of connector. F. Crimp sleeve using Hex type Die or equivalent. G. Retention after crimp is normally 60 lbs./Minute. Note: Hex Diameter .213/.217 after crimp. All dimensions are in inches and metric. All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 5/21/02 SY/EH/LS Last saved by PN Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering\Release\DataSheets\FlukeDataSheet \d_AI_5285_2_02.doc PomonaACCESS 90117 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 2 of 2