Pomona ® Model 5307 & Assembly Instructions Connector BNC (M), RG174 With Hardware FEATURES: • Connector to accept Types RG: 174, 179A, 179B, 187, 187A, 188, 188A and 316/U • Connector shall meet interface requirements of MIL-STD-348 MATERIALS: Body and Hardware – Brass Center Contact – Gold Plated Brass Dielectric – PTFE Gasket – Silicone Rubber Finish: Body and Hardware – Tarnish Resistant Center Contact – Gold Plated RATINGS: Operating Voltage: 500 VRMS Max. Nominal Impedance: 50 Ohms ORDERING INFORMATION: Model 5307 All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 6/9/99 SY/EH/LS Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering \Release\DataSheets\FlukeDataSheet\d_AI_5307_1_01.doc PomonaACCESS 90119 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 1 of 2 Pomona ® Model 5307 & Assembly Instructions Connector BNC (M), RG174 With Hardware FIGURE #1 A. Slide clamp nut, gasket and washer over cable. B. Trim outer jacket from cable. FIGURE #2 C. Fold back braid and push ferrule over dielectric to trap braid between outer jacket and the ferrule. Trim excess braid. FIGURE #3 D. Trim back dielectric FIGURE #4 & 4A E. Slide rear insulator over dielectric until it stops against the ferrule. FIGURE #5 F. Solder contact onto center conductor, press collar into recess in rear of insulator. FIGURE #6 G. Slide washer, gasket and clamp nut up to ferrule trapping briad. H. Fit front insulator over contact and press into body. I. Tighten clamp nut. All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 6/9/99 SY/EH/LS Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering \Release\DataSheets\FlukeDataSheet\d_AI_5307_1_01.doc PomonaACCESS 90119 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 2 of 2