DC-AC INVERTER UNIT CXA-0385 (16 W QUAD OUTPUTS WITH DIMMING FUNCTION) (PRELIMINARY INFORMATION) DESCRIPTION : This low profile DC to AC Inverter is developed for Quad lamps, low power LCD back-light. APPLICABLE LCD: AA150XN02 (MITSUBISHI) AA150XN03 (MITSUBISHI) AA150XN04 (MITSUBISHI) T-351863D150-FW-A-AB (OPTREX) 6.4 to 15 inches Quad lamp type Lamp Voltage 600 Vrms Lamp Current 6.5 mArms Lamp Start Up Voltage 1.600 Vrms (Vin : 12.0 Vdc) FEATURES : Dimming function PWM Remote ON/OFF Open Lamp Detection TEMPERATURE & HUMDITY : Operating Temperature Range Storage Temperature Range Humidity 0°C ~ +70°C -30°C ~ +85°C 95 %RH max 150±0.5 144±0.3 (3) (3) (3) DIMENSIONS : 44±0.3 50±0.5 4 3 CN5 1 1 CXA-0385 3Z05 MADE IN CHINA T2 1 CN4 CN2 1 Unit : mm Weight :43 (g) typ. T1 1 1 SILICON SILICON (3) CN1 1 CN3 LED (This LED shows the condition of High Voltage.) (1) 8.5 MAX Note: Please use plastic screw in case of a non-insulating mounting base! Components No. 1 2 3 4 Part Discription PWB Connector CN1 Connector CN2/CN4 Connector CN3/CN5 Input side CN1: Pin No. Symbols Vin CN 1-1~2 GND CN 1-3~4 CN 1-5 CN 1-6 Vbr / Rbr Vs t CN 1-7 Vrm t Qty. 1 1 2 2 Material Conpos ite (CEM-3) S7B-PH-SM3 SM02B-BHSS-1-TB SM02(4.0)B-BHS-1-TB Note t=1m m JST or equal JST or equal JST or equal Output side CN2/CN4 Ratings 10.8 ~ 13.2 Vdc Pin No. CN 2-1 CN 2-2 0 ~ 2.5 Vdc / 0 ~ 50 kΩ Symbols Vhigh1 Vhigh2 Ratings 600 Vrm s (6.5 m Arm s ) 600 Vrm s (6.5 m Arm s ) Output side CN3/CN5 0 / 5.0 Vdc 0 ~ 0.4 Vdc: Off 2.5 ~ Vin: On Pin No. CN 3-1 CN 3-2 Symbols Vlow1 Vlow2 Ratings (GND) (GND) Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specification are subject to change without notice. Address: Dörnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 80 Page (1) VER 1-1 TO, 03 Nov 2004 DC-AC INVERTER UNIT CXA-0385 (16 W QUAD OUTPUTS WITH DIMMING FUNCTION) (PRELIMINARY INFORMATION) ELECTRICAL CHARACTERISTICS : Parameters Symbols Output Current Output Current Input Current Input Current Frequency Frequency (Duty) Open Circuit Voltage Iout1 Iout2 Iin1 Iin2 F1 F2 Vopen Alarm Signal Vs t Note 1 : Conditions Vrmt Vbr (V) (V) 5±0.25 0 5±0.25 2.5 5±0.25 0 0 0 ~ 2.5 5±0.25 0 5±0.25 2.5 5±0.25 0 5±0.25 0 Vin (V) 12.0±1.2 12.0±1.2 12.0±1.2 12.0±1.2 12.0±1.2 12.0±1.2 12.0±1.2 12.0±1.2 12.0±1.2 5±0.25 Specification Tu (°C) 0 0 0 0 0 0 0 0 Min. ~ +70 6.0 ~ +70 2.3 ~ +70 ~ +70 ~ +70 45 ~ +70 240 ~ +70 1.500 ~ +70 - 0 ~ 2.5 0 ~ +70 4.5 Typ. Max. 6.5 3.0 1.7 50 270 1.600 0.0 7.0 3.7 2.0 1 55 300 - 5.0 5.5 Unit Note m Arm s m Arm s Adc m Adc kHz Hz kVrm s Vdc M ax Vdc M ax Remo te Of f Normal op erat ion A larm Sig nal Please keep minimum of 2mm clearance (all directions) between inverter high voltage area as marked on mechanical drawing and any conductors. TEST CIRCUIT : CL1 Vin 10.8~13.2V A Iin CN1-1.2 Vin T1 Q8 1 C06 6 SW1 CN2-1 Vhigh1 V 3 4 9 SW4 CN1-3.4 GND Vbr 0~2.5V V a Iout1 CN2-2 Vhigh2 RL2 SW5 A ~ CN3-2 Vlow2 CN1-5 Vbr SW6 Operation b Non Operation OPEN Non Operation SW2 Operation of Unit Iout2 a Voltage dimming Vbr=0~2.5V (Vbr=0V : Max Brightness) b Variable resistance dimming Rbr=0~50kΩ (Rbr=0Ω : Max Brightness) CL3 1 CN1-6 Vst Operation of Unit a CL2 C07 b Rbr 0~50kW (0.025W~) A ~ CN3-1 Vlow1 5 SW2 RL1 SW3 2 T2 6 C08 F1 CN4-1 Vhigh3 V 3 4 Vst RL3 SW7 2 A ~ CN5-1 Vlow3 9 SW8 5 Iout3 CL4 C09 Vrmt 5V a V b SW1 CN4-2 Vhigh4 CN1-7 Vrmt RL4 SW9 A ~ CN5-2 Vlow4 SW10 F 1000:1 V ~ Iout4 RL1,2,3,4 : Load resistance (7W MIN.) CL1,2,3,4 : Stray capacitor (3kV MIN.) Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specification are subject to change without notice. Address: Dörnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 80 Page (2) VER 1-1 TO, 03 Nov 2004