OCO-M36AGS Low G-sensitivity OCXO Sine wave Features Low G-sensitivity stability 1.0 x 10-9 /g High frequency stability vs. temperature (up to ±7.5 x 10-9) Low phase noise optional Specification Parameter OCO-M36AGS5 Frequency range Standard frequencies OCO-M36AGS12 5.0000 ~ 20.0000 MHz 5.00, 10.00, 12.80, 13.00, 16.384 & 20.00 MHz ≤ ±2.0 x 10-9 over -40 ~ +85 °C ≤ ±1.0 x 10-9 over -20 ~ +70 °C ≤ ±7.5 x 10-10 over -10 ~ +60 °C -10 ≤ ±5 x 10 ±5 % -10 ±5 % ≤ ±5 x 10 ≤ ±3 x 10-8 1st year -12 < 5 x 10 Allan deviation per 1 s -9 < 1.5 x 10 /g optional < 1.0 x 10-9 /g sine wave > 300 mV (rms) 50 Ω ±5 % +5.0 V ±5 % +12 V ±5 % < 400 mA < 150 mA < 950 mA < 400 mA < 3 min < ±1 x 10-7 @ +25 °C > ±4 x 10-7 positive slope 0 ~ +4.5 V 0 ~ +5.0 V +4.5 V +5.0 V < -130 dBc/Hz @ 10 Hz < -153 dBc/Hz @ 100 Hz < -158 dBc/Hz @ 1 kHz < -160 dBc/Hz @ 10 kHz Frequency stability vs. operating temperature range vs. supply voltage change vs. load change vs. aging after 30 days of operation Short term stability G-sensitivity (in the range 0 ~ 500 Hz) Output waveform Output load Supply voltage Steady-state current consumption @ +25 °C Peak current consumption during warm-up time Warm-up time Frequency pulling range Voltage control (Vc) Reference voltage output (Vref) Phase noise @ 10 MHz carrier frequency Low phase noise for Vdc = 12 V Harmonics > 30 dBc Operating temperature range Storage temperature range -10 ~ +60 °C, Case height (H) -20 ~ +70 °C, -40 ~ +70 °C -55 ~ +85 °C or -40 ~ +85 °C 12.7 mm or 16.0 mm Environmental test vibration shock acceleration: 5 g; 10 Hz up to 200 Hz and down to 10 Hz; all 3 axes, 4.5 h/axis 75 g, half-sine, 3 ms (3 shocks each, 6 directions) Pin function #1 #2 #3 #4 #5 Vc Vref Vdc RF output GND Circuit diagram CBP = 0.01 mF ZOUT = 50 Ω 2002/95/EC RoHS compliant QuartzCom AG [email protected] www.quartzcom.com QuartzCom Asia [email protected] QuartzCom USA [email protected] 12 Dec. 10