RECTRON FM2500W SEMICONDUCTOR TECHNICAL SPECIFICATION HIGH VOLTAGE RECTIFIER VOLTAGE 2500 Volts CURRENT 0.15 Ampere FEATURES * * * * Low cost Low leakage Low forward voltage drop High current capability SMX MECHANICAL DATA Case: Molded plastic Epoxy: Device has UL flammability classification 94V-O Lead: MIL-STD-202E method 208C guaranteed Mounting position: Any .209 (5.31) .185 (4.70) .110 (2.79) .086 (2.18) .180 (4.57) .160 (4.06) .091 (2.31) .067 (1.70) .008 (0.20) .011 (0.28) .007 (0.18) .067 (1.70) .051 (1.30) .010 (0.25) * * * * MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 o C ambient temperature unless otherwise specified. .059 (1.50) .035 (0.89) Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in inches and (millimeters) MAXIMUM RATINGS (At T A = 25oC unless otherwise noted) SYMBOL FM2500W UNITS Maximum Recurrent Peak Reverse Voltage RATINGS VRRM 2500 Volts Maximum RMS Volts VRMS 1750 Volts VDC 2500 Volts IO 0.15 Amps I FSM 30 Amps I FSM 3.0 Amps pF Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at T A = 50 oC Peak Forward Surge Current, 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Peak Forward Surge Current, 10 ms single half sine-wave superimposed on rated load at 105oC (JEDEC method) Typical Junction Capacitance (Note) Operating and Storage Temperature Range CJ 35 T J , T STG -55 to + 150 SYMBOL FM2500W 2.0 0 C o ELECTRICAL CHARACTERISTICS (At TA = 25 C unless otherwise noted) CHARACTERISTICS Maximum Instantaneous Forward Voltage at 0.15A DC Maximum DC Reverse Current at Rated DC Blocking Voltage @T A = 25 o C @T A =100 o C Maximum Full Load Reverse Current Average, Full Cycle .375”, (9.5mm) lead length at TL = 75oC NOTES : Measured at 1 MHZ and applied reverse voltage of 4.0 volts. VF 5.0 IR UNITS Volts uAmps 50 30 uAmps 2004-8 FIG. 1 - TYPICAL FORWARD CURRENT DERATING CURVE PEAK FORWARD SURGE CURRENT, (A) FIG. 2 - MAXIMUM NON-REPETITIVE FORWARD 150 Single Phase Half Wave 60Hz Inductive or Resistive Load 120 90 60 30 0 0 SURGE CURRENT 70 60 8.3ms Single Half Sine-Wave (JEDEC Method) 50 40 30 20 10 0 1 50 100 150 175 AMBIENT TEMPERATURE, ( ) INSTANTANEOUS REVERSE CURRENT, (uA) AVERAGE FORWARD CURRENT, (mA) RATING AND CHARACTERISTIC CURVES ( FM2500W ) 10 100 NUMBER OF CYCLES AT 60Hz FIG. 3 - TYPICAL REVERSE CHARACTERISTICS 10 1.0 TJ = 25 0.1 .01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) RECTRON