UNISONIC TECHNOLOGIES CO., LTD DTA123Y PNP SILICON TRANSISTOR DIGITAL TRANSISTORS (BUILT- IN BIAS RESISTORS) FEATURES * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow positive input. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Lead Free Halogen Free DTA123YL-AE3-R DTA123YG-AE3-R Note: Pin Assignment: G: GND I: IN O: OUT Package SOT-23 Pin Assignment 1 2 3 G I O Packing Tape Reel MARKING www.unisonic.com.tw Copyright © 2011 Unisonic Technologies Co., Ltd 1 of 2 QW-R206-070.Ba DTA123Y PNP SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C) PARAMETER SYMBOL RATINGS UNIT VCC -50 V VIN -12 ~ +10 V IOUT -100 Output Current mA IC(MAX) -100 Power Dissipation PD 200 mW Junction Temperature TJ +150 °C Storage Temperature TSTG -55 ~ +150 °C Note Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Supply Voltage Input Voltage ELECTRICAL SPECIFICATIONS (TA=25°C) PARAMETER SYMBOL VIN(OFF) Input Voltage VIN(ON) Output Voltage VOUT(ON) Input Current IIN Output Current IOUT(OFF) DC Current Gain GIN Input Resistance R1 Resistance Ratio R2/R1 Transition Frequency fT Note: Transition frequency of the device TEST CONDITIONS VCC =-5V, IOUT =-100μA VOUT =-0.3V, IOUT =-20mA IOUT/IIN =-10mA/-0.5mA VIN=-5V VCC =-50V, VIN =0V VOUT =-5V, IOUT =-10mA VCE =-10V, IE =−5mA, f=100MHz (Note) MIN TYP MAX -0.3 UNIT -0.3 -3.8 -0.5 V mA μA 2.86 5.5 KΩ -3 33 1.54 3.6 2.2 4.5 250 V MHz UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 2 QW-R206-070.Ba