RoHS PCHC1354S Power Choke High Current Dimensions: Inches (mm) Allied Part Number Inductance (µ h) Tolerance (%) Test Freq. KHz,1v DCR (Ω) Max Isat (A) Irms (A) Max. PCHC1354S-R68M-RC 0.68 20 100 1.5 38.8 29.7 PCHC1354S-1R0M-RC 1.00 20 100 2 34 26 PCHC1354S-1R4M-RC 1.40 20 100 3.4 26 22 PCHC1354S-2R2M-RC 2.20 20 100 4.5 20 18 PCHC1354S-3R3M-RC 3.30 20 100 7 18 15 PCHC1354S-4R7M-RC 4.70 20 100 8.8 15 13 PCHC1354S-6R8M-RC 6.80 20 100 12 12 9 All specifications subject to change without notice. Land Pattern Features • • • • • Magnetically shielded construction High saturation current up to 38.8A Expanding operating temp range Low DCR resistance Suitable for pick and place Electrical Inductance Range: .68µH to 6.8µH Additional values available Tolerance: 20% over entire range, Available in tighter tolerances Test Frequency: 100KHz, 1.0Vdc Operating Temp: -55ºC ~ +125ºC Storage Temp: -55ºC ~ +125ºC Temp rise: ∆ T=40ºC Typical at rated Irms with out core loss. Part temperature should not exceed 125ºC including temperature rise. Inductance drop: 20% typical at rated Isat Resistance to Soldering Heat Pre-Heat 150ºC, 1 minute. Solder Composition: Sn/Ag3.0/Cu0.5 Solder Temp: 260ºC ± 5ºC Immersion Time: 10 sec. ± 1 sec. Test Equipment (L): HP 4284A LCR meter or equivalent (DCR): CH16502, Agilent 33420A Micro-Ohm meter Schematic (IDC): 3260B WK & DC Bias 3265B WK Physical Packaging: 500 pieces per 13 inch reel. Marking: EIA Inductance Code 714-665-1140 ALLIED COMPONENTS INTERNATIONAL REVISED 15 8/04/09 www.alliedcomponents.com