RoHS PCHC63H Power Choke High Current Dimensions: Inches (mm) Allied Part Number Inductance (µh) Tolerance (%) Test Freq. KHz,1v DCR (Ω) Max Isat (A) Irms (A) Max. PCHC63H-R33M-RC 0.33 20 100 3.9 30 20 PCHC63H-R47M-RC 0.47 20 100 4.2 26 17.5 PCHC63H-R68M-RC 0.68 20 100 5.5 23 15.5 PCHC63H-1R0M-RC 1.00 20 100 10 16 11 PCHC63H-1R5M-RC 1.50 20 100 15 14 9 PCHC63H-2R2M-RC 2.20 20 100 20 12 8 PCHC63H-3R3M-RC 3.30 20 100 30 10 6 PCHC63H-4R7M-RC 4.70 20 100 40 6.5 5.5 PCHC63H-6R8M-RC 6.80 20 100 60 6 4.5 PCHC63H-100M-RC 10 20 100 105 4.5 3 All specifications subject to change without notice. Schematic Features • • • • • Magnetically shielded construction High saturation current up to 30A Expanding operating temp range Low DCR resistance Suitable for pick and place Electrical Inductance Range: .33µH to 10µH Available in tighter tolerances Tolerance: 20% over entire range, Test Frequency: 100KHz, 1.0Vdc Operating Temp: -55ºC ~ +125ºC Storage Temp: -55ºC ~ +125ºC Temp rise: ∆ T=40ºC Typical at rated Irms with out core loss. Part temperature should not exceed 125ºC including temperature rise. Inductance drop: 20% typical at rated Isat Resistance to Soldering Heat Pre-Heat 150ºC, 1 minute. Solder Composition: Sn/Ag3.0/Cu0.5 Solder Temp: 260ºC ± 5ºC Immersion Time: 10 sec. ± 1 sec. Test Equipment (L): HP 4284A LCR meter or equivalent (DCR): CH16502, Agilent 33420A Micro-Ohm meter (IDC): 3260B WK & DC Bias 3265B WK Physical Packaging: 1000 pieces per 13 inch reel. Marking: EIA Inductance Code 714-665-1140 ALLIED COMPONENTS INTERNATIONAL REVISED 15 7/16/09 www.alliedcomponents.com