RoHS PCHC64P Power Choke High Current Dimensions: Inches (mm) Allied Part Number Inductance (µh) Tolerance (%) Test Freq. KHz,1v DCR (Ω) Max Isat (A) Irms (A) Max. PCHC64P-R33M-RC 0.33 20 100 1.4 32 25 PCHC64P-R47M-RC 0.47 20 100 2.5 30 20 PCHC64P-R68M-RC 0.68 20 100 3.8 28 17 PCHC64P-1R0M-RC 1.00 20 100 5.8 20 15 PCHC64P-1R5M-RC 1.50 20 100 8.4 18 16 PCHC64P-2R2M-RC 2.20 20 100 15 14 12 PCHC64P-3R3M-RC 3.30 20 100 18 13 10 PCHC64P-4R7M-RC 4.70 20 100 21 9 7 PCHC64P-6R8M-RC 6.80 20 100 30 7 5.5 PCHC64P-100M-RC 10 20 100 60 5 4.5 All specifications subject to change without notice. Schematic Features • • • • • Magnetically shielded construction High saturation current up to 32A Expanding operating temp range Low DCR resistance Suitable for pick and place Electrical Inductance Range: .33µH to 10µH Additional values available Tolerance: 20% over entire range, Available in tighter tolerances Test Frequency: 100KHz, 1.0Vdc Operating Temp: -55ºC ~ +125ºC Storage Temp: -55ºC ~ +125ºC Temp rise: ∆ T=40ºC Typical at rated Irms with out core loss. Part temperature should not exceed 125ºC including temperature rise. Inductance drop: 20% typical at rated Isat Resistance to Soldering Heat Pre-Heat 150ºC, 1 minute. Solder Composition: Sn/Ag3.0/Cu0.5 Solder Temp: 260ºC ± 5ºC Immersion Time: 10 sec. ± 1 sec. Test Equipment (L): HP 4284A LCR meter or equivalent (DCR): CH16502, Agilent 33420A Micro-Ohm meter (IDC): 3260B WK & DC Bias 3265B WK Physical Packaging: 1000 pieces per 13 inch reel. Marking: EIA Inductance Code 714-665-1140 ALLIED COMPONENTS INTERNATIONAL REVISED 15 7/16/09 www.alliedcomponents.com