revision for dwg # 1PB-P2APx 5 rev ch.no. - - date description original design 11/5/2007 1 n24.5 mm [1.0 in] n28.8 mm 2 max. 4 mm [.16 in] 42 mm [1.7 in] revised by Philipp E. 18 mm [.7 in] 66 mm [2.6 in] [1.1 in] 6 4 90 mm [3.5 in] 3 11 mm [.4 in] 19.5 mm [.8 in] ITEM DESCRIPTION Up tp six switch contacts can be installed. * = Push button is supplied with rubber gasket, mounting nut and mounting bracket (ITEM 1,2,3 and 4) ** = Switch Contacts must be ordered separatly unless otherwise specified: all dimensions are in millimeters third angle projection tolerance XX XX.X XX.XX ALL = = = = ±1 mm ±0.5 mm ±0.2 mm − mm R 35 Royal Road Flemington, NJ 08822-6000 (908) 806-9400 Fax (908) 806-9490 Push Button, Projecting 2* 3* 4* 5 Rubber Gasket Mounting Nut Mounting Bracket Panel 6** Switch Contacts This Drawing is the property of M E T R I C 1* and is a confidential disclosurelent without consideration other than the borrower’s agreement that it shall not be reproduced, copied, lent or disposed of directly or indirectly nor used for any purpose other than that for which it is specifically furnished. titel CAT. NO. P2AP2 P2AP3 P2AP4 P2AP6 P2AP8 2PRG1 P2MN P2BRK S1 S2 S3 S4 COLOR MIN. QTY. MAX. QTY. Black 1 1 Green 1 1 Red 1 1 Blue 1 1 Yellow 1 1 Black 1 1 Black 1 1 Black 1 1 Green 1 6 Red 1 6 Green/Gray 1 6 Red/Gray 1 6 22 mm Thermoplastic Enclosure Projecting Push Button P2APx (x=color) drawn by: Philipp Ernstberger checked by: Laszlo Gyorgypal released by: Laszlo Gyorgypal 11/5/2007 drawing no.: 11/5/2007 1PB-P2APx 11/5/2007 scale: rev.: - sheet: 1 of: 1