MUR105GP THRU MUR160GP Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 Features • • • • 1.0 Amp Glass Passivated Super Fast Recovery Rectifier 50 to 600 Volts High Surge Capability Low Forward Voltage Drop High Current Capability Super Fast Switching Speed For High Efficiency Maximum Ratings • • Operating Temperature: -65°C to +150°C Storage Temperature: -65°C to +150°C Part Number MUR105GP MUR110GP MUR115GP MUR120GP MUR140GP MUR160GP Maximum Recurrent Peak Reverse Voltage 50V 100V 150V 200V 400V 600V DO-41 Maximum RMS Voltage Maximum DC Blocking Voltage 35V 70V 105V 140V 280V 420V 50V 100V 150V 200V 400V 600V D Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 1.0A TA = 55°C Current Peak Forward Surge IFSM 25A 8.3ms, half sine Current Maximum Instantaneous Forward Voltage VF IFM = 1.0A; MUR105GP-115GP .97V 1.35V TA = 25°C MUR120GP-160GP Maximum DC 5.0µA TA = 25°C Reverse Current At IR Rated DC Blocking TA = 150°C 50µA Voltage Maximum Reverse Recovery Time Trr MUR105GP-140GP 45ns IF=0.5A, IR=1.0A, Irr=0.25A 60ns MUR160GP Typical Junction Capacitance CJ MUR105GP-115GP 15pF Measured at 10pF 1.0MHz, VR=4.0V MUR120GP-160GP *Pulse Test: Pulse Width 300µsec, Duty Cycle 1% A Cathode Mark B D C DIMENSIONS INCHES DIM A B C D MIN .166 .080 .028 1.000 www.cnelectr.com MAX .205 .107 .034 --- MM MIN 4.10 2.00 .70 25.40 MAX 5.20 2.70 .90 --- NOTE MUR105GP thru MUR160GP Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 1.5 6 4 MUR105GP-115GP 1.25 2 25°C Amps 1.0 1 .6 .75 Amps .4 .5 .2 MUR120GP-160GP .25 .1 .06 0 .04 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 50 75 100 125 150 175 °C .02 .01 .7 .5 .9 1.1 1.3 Average Forward Rectified Current - Amperes versus Ambient Temperature - °C 1.5 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 MUR105GP-115GP 60 40 MUR120GP-160GP 20 pF TJ=25°C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 Junction Capacitance - pF versus Reverse Voltage - Volts www.cnelectr.com 400 1000 MUR105GP thru MUR160GP Figure 4 Typical Reverse Characteristics Figure 5 Peak Forward Surge Current 100 30 60 40 TA=150°C 20 20 10 6 Amps 4 10 2 TA=100°C 0 µAmps 1 1 4 2 .6 6 8 10 20 40 60 80 100 Cycles .4 Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles .2 TA=25°C .1 .06 .04 .02 .01 2 60 4 80 100 120 140 Volts Instantaneous Reverse Leakage Current - MicroAmperes versus Percent Of Rated Peak Reverse Voltage - Volts Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.mccsemi.com