RGP30A THRU RGP30M Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 Features • • • • • 3.0 Amp Glass Passivated Junction Fast Recovery Rectifiers 50 to 1000 Volts High temperature metallurgically bonded construction Glass passivated cavity-free junction 3.0 amperes operation at TA=55OC and with no thermal runaway. Typical IR less than 0.2uA Fast switching for high efficiency Maximum Ratings • • • DO-201AD Operating Temperature: -55OC to +150 OC Storage Temperature: -55OC to +150 OC Typical Thermal Resistance: 25OC/W Junction to Ambient Part Number RGP30A RGP30B RGP30D RGP30G RGP30J RGP30K RGP30M Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage Maximum DC Blocking Voltage 35V 70V 140V 280V 420V 560V 700V 50V 100V 200V 400V 600V 800V 1000V D A Cathode Mark B D Electrical Characteristics @ 25OC Unless Otherwise Specified Maximum Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time RGP30A-30G RGP30J RGP30K-30M Typical Junction Capacitance IF(AV) 3.0 A TA = 55OC IFSM 125A 8.3ms, half sine C DIMENSIONS VF IR Trr CJ 1.3V IFM = 3.0A; 5.0uA 100uA TA=25OC TA=150 OC 150nS 250nS 500nS 60pF TJ =25OC IF=0.5A IR=1.0A IRR=0.25A Measured at 1.0MHz, VR=4.0V DIM A B C D INCHES MIN ----.048 1.000 www.cnelectr.com MAX .370 .250 .052 --- MM MIN ----1.20 25.40 MAX 9.50 6.40 1.30 --- NOTE RGP30A thru RGP30M Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 3.0 6 4 2.5 2 Amps 25OC 2.0 1 .6 1.5 Amps .4 1.0 .2 .5 .1 .06 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 .04 50 0 125 .4 .6 .8 1.0 1.2 1.4 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF 150 175 O C Average Forward Rectified Current - Amperes versus Ambient Temperature - OC .02 .01 100 75 TJ =25OC 10 6 4 2 1 .1 .2 .4 1 2 4 10 Volts 20 40 100 200 Junction Capacitance - pF versus Reverse Voltage - Volts www.cnelectr.com 400 1000 RGP30A thru RGP30M Figure 4 Peak Forward Surge Current 200 100 80 60 Amps 40 20 01 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.cnelectr.com