THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT DATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 3.3V LVMOS STRATUM 3 OCVCXO ABSOLU TE MAX IMUM R ATINGS PARAMETER UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C Storage Temperature NOTE Supply Voltage (Vcc) -0.5 - 4.5 Vdc Control Voltage (Vc) -0.5 - 4.5 Vdc NOMINAL MAXIMUM UNITS (Fo) MINIMUM 1.544 - 20.0 1.5 MHz ppm 1 -0.25 -30 -2.5 -4.6 0 - 0.25 30 2.5 4.6 70 ppm ppb ppm ppm °C 2 3 Vdc OPERATING SPECIFICAT IONS Frequency Calibration, Vc=1.48 Vdc -1.5 Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 450 mA Phase Jitter (BW=12KHz to 20MHz) - - 1 ps rms Phase Jitter (BW=10Hz to 20MHz) - - 3 ps rms Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - -90 -135 - 5 10 5 1 2 ps rms dBc/Hz dBc/Hz mS Minutes nS nS MINIMUM NOMINAL MAXIMUM UNITS 0.3 -22.5 13.5 5 100k 1.48 - 3.0 -13.5 22.5 - Vdc ppm ppm ppm/V Ohm INPUT CHARACTERISTICS PARAMETER Control Voltage Range Frequency at Vc=0.3 Vdc Frequency at Vc=3.0 Vdc Slope of Frequency Adjust Input Impedance AGOV3S3 TABLE 2.0 PARAMETER Center Frequency CW 0643 AGOV3S3 12.8M TABLE 1.0 (Vc) NOTE 4 DESCRIPTION The Connor-Winfield AGOV3S3 is a hermetically sealed 14 Pin DIP 3.3V Oven Controlled Voltage controlled Crystal Oscillator (OCVCXO) with an LVMOS output. The AGOV3S3 is designed for Stratum 3 applications requiring low jitter and tight frequency stability. 5 FEATURES TABLE 3.0 NOTE 6 6 3.3V OPERATION VOLTAGE CONTROLLED FREQUENCY ADJUST LOW JITTER <1pS RMS FREQUENCY STABILITY ±0.25ppm LVMOS OUTPUT CHARACT ERISTICS TABLE 4.0 PARAMETER LOAD Voltage (High) (Low) (Voh) (Vol) MINIMUM 2.6 - Current (Ioh) -4 (Ioh) 45 - (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% NOMINAL - MAXIMUM 15 0.4 UNITS pf Vdc Vdc - mA 4 55 6 mA % nS 50 - TEMPERATURE RANGE: 0 to 70°C HERMETICALLY SEALED 14 PIN PACKAGE RoHS 5/6 COMPLIANT 14 pin DIP, hermetically sealed, grounded case, welded package Notes: 1) 2) 3) 4) Initial calibration @ 25°C, Vc=1.48 Vdc. Frequency vs. temperature stability At the time of shipment after48 hours of opera tion. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=1.48 Vdc. 5) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25°C 6) Referenced to Fo @ 25°C, positive transfer characteristic. DATA SHEET #: OVERALL FREQUENCY TOLERANCE: ±4.6ppm OVER TWENTY YEARS TABLE 5.0 PACKAG E CHARACTERISTICS Package NOTE Cx018 PAGE 1 OF 2 REV: 03 DATE: 10/23/06 ORDERING INFORMATION AGOV3S3 OCXO SERIES - 12.800MHz CENTER FREQUENCY Specifications subject to change without notice. aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260°C ±5°C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. SOLDER PROFILE PACKAGE OUTLINE Temperature 225°C Ramp-Up Rate 3°C/second max. from 150°C to 225°C. 225°C tp Ramp-Down Rate 6°C/second max. 183°C 150°C 100°C 25°C CONTROL VOLTAGE 0 Time 60-120s Max. 10-30s 60-150s Max. 360 Sec. Max. TEST DIAGRAM 3.0Vdc 3.3Vdc 14 8 1 7 Specifications subject to change without notice. DATA SHEET #: Cx018 PAGE 2 OF 2 REV: 03 DATE: 10/23/06 aCopyright 2001 Connor-Winfield all rights reserved.