THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS 3.3V 14 PIN LVPECL VCXO OSCILLATOR WITH ENABLE / DISABLE FUNCTION ABSOLUTE M AXIMUM RATING S PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM -55 - 125 °C Supply Voltage (Vcc) -0.5 - 7.0 Vdc Control Voltage (Vc) -0.5 - 7.0 Vdc Storage Temperature UNITS OPERATING SPECIFIC ATIONS CW 0735 PVL54I90G5 155.52M NOTE PVL54I90G5 TABLE 2.0 PARAMETER Center Frequency MINIMUM NOMINAL 86.097902 155.5200 166.6285 MAXIMUM -10 -5 -5 -20 0 - - 10 5 5 20 70 ppm ppm ppm ppm °C Vdc (Fo) Frequency vs. Temperature Frequency vs. Calibration @ 25°C Frequency vs. Aging (10 years) Total Frequency Tolerance Operating Temperature Range UNITS NOTE DESCRIPTION MHz Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 80 mA Jitter (BW=10Hz to 20MHz) - - 5 ps rms Jitter (BW=12kHz to 20MHz) SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset - -80 -100 -130 -135 1 - ps rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz MINIMUM 0.3 +/-45 +/-30 -10 50K NOMINAL 1.65 - MAXIMUM 3.0 +/-90 10 - UNITS Vdc ppm ppm % Ohm 10 - 2.26 1.70 - kHz Vdc Vdc INPUT CHARACTERISTICS 1 1 2 The Connor-Winfield PVL54I90G5 is a 3.3V Voltage controlled crystal oscillator (VCXO) with Differential PECL outputs. Based on a fundamental design the PVL54I90G5 is designed for phased lock loop applications requiring low jitter and tight frequency stability. TABLE 3.0 PARAMETER Control Voltage Range Frequency Pullability @ 25 °C Absolute Pull Range Monotonic Linearity Input Impedance (Vc) Modulation Bandwidth (3dB) Disable Input Voltage (High) Enable Input Voltage (Low) (Vih) (Vil) NOTE FEATURES 3 4 3.3V OPERATION LOW JITTER <1ps RMS 5 5 TOTAL FREQUENCY TOLERANCE: ±20PPM TEMPERATURE RANGE: 0 to 70°C LVPECL OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Duty Cycle at 50% Level Rise / Fall Time 20% to 80% (Voh) (Vol) TABLE 4.0 MINIMUM 2.26 45 - NOMINAL 50 - MAXIMUM 50 1.70 55 1.0 UNITS Ohms Vdc Vdc % nS NOTE 6 DIFFERENTIAL LVPECL OUTPUTS ENABLE/DISABLE FUNCTION HERMETICALLY SEALED DIP PACKAGE RoHS 5/6 COMPLIANT PACKAG E CHARACTERISTICS TABLE 5.0 Package Notes 1.0 2.0 3.0 4.0 5.0 6.0 Hermetically sealed metal 14 pin package. Control Voltage @ 1.65V Includes initial tolerance, deviation over temperature, supply and load variations, shock, vibration and aging. Referenced to Fo at 1.65V, Positive Slope. Absolute pull range (APR) is the minimum guaranteed pull range of the VCXO under all conditions over lifetime operation. The APR is referenced to Fo. When oscillator is disabled the true output is in a low state (Vol) and the complementary output is in the high state (VoH) Output terminated into 50 ohms into Vcc – 2.0Vdc or Thevenin equivalent. ORDERING INFORMATION PVL54I90G5 - 155.52 MHz VCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Vx576 PAGE 1 OF 2 REV: 00 DATE: 09/18/06 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS Package Outline Solder Profile Temperature 225°C Ramp-Up Rate 3°C/second max. from 150°C to 225°C. 225°C tp Ramp-Down Rate 6°C/second max. 183°C 150°C 100°C 25°C 0 Time 60-120s Max. 10-30s 60-150s Max. 360 Sec. Max. Pin Connections Output Waveform Test Circuit Specifications subject to change without notice. DATA SHEET #: Vx576 PAGE 2 OF 2 REV: 00 DATE: 09/18/06 aCopyright 2001 Connor-Winfield all rights reserved.