FR1A DC COMPONENTS CO., LTD. R THRU RECTIFIER SPECIALISTS FR1K TECHNICAL SPECIFICATIONS OF SURFACE MOUNT FAST RECOVERY RECTIFIER VOLTAGE RANGE - 50 to 800 Volts CURRENT - 1.0 Ampere FEATURES * ldeal for surface mounted applications * Low leakage current * Glass passivated junction SMB ( DO-214AA ) .083(2.11) .075(1.91) MECHANICAL DATA * Case: Molded plastic * Epoxy: UL 94V-0 rate flame retardant *Terminals: Solder plated, solderable per MIL-STD-750, Method 2026 * Polarity: As marked * Mounting position: Any * Weight: 0.093 gram .185(4.70) .160(4.06) .060(1.52) .030(0.76) .220(5.59) .200(5.08) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS o Ratings at 25 C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in inches and (millimeters) SYMBOL FR1A FR1B FR1D FR1G FR1J FR1K UNITS Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 Volts VDC 50 100 200 400 600 600 Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at TA = 75 oC IO Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum Instantaneous Forward Voltage at 1.0A DC Maximum DC Reverse Current @T A = 25 o C at Rated DC Blocking Voltage @T A = 100 o C Maximum Reverse Recovery Time (Note 3) Typical Thermal Resistance (Note 2) Typical Junction Capacitance (Note 1) Operating and Storage Temperature Range Volts 1.0 Amps I FSM 30 Amps VF 1.3 Volts 5.0 IR uAmps 150 trr 150 RθJL 250 12 CJ 30 T J, T STG -65 to + 175 500 nSec 0 C/ W pF 0 C NOTES : 1. Measured at 1 MHz and applied reverse voltage of 4.0 volts. 2. Thermal Resistance (Junction to Ambient), 0.2x0.2in2 (5X5mm2 ) copper pads to each terminal. 3. Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A. 334 EXIT EXI BACK NEXT BACK EXIT NEXT BACK NEXT RATING AND CHARACTERISTIC CURVES ( FR1A THRU FR1K ) DC COMPONENTS CO., LTD. R 335 NEXT EXIT EXI BACK NEXT BACK EXIT NEXT BACK