S1A DC COMPONENTS CO., LTD. R THRU RECTIFIER SPECIALISTS S1M TECHNICAL SPECIFICATIONS OF SURFACE MOUNT SILICON RECTIFIER VOLTAGE RANGE - 50 to 1000 Volts CURRENT - 1.0 Ampere FEATURES * ldeal for surface mounted applications * Low leakage current * Glass passivated junction SMB ( DO-214AA ) .083(2.11) .075(1.91) MECHANICAL DATA * Case: Molded plastic * Epoxy: UL 94V-0 rate flame retardant *Terminals: Solder plated, solderable per MIL-STD-750, Method 2026 * Polarity: As marked * Mounting position: Any * Weight: 0.093 gram .185(4.70) .160(4.06) .060(1.52) .030(0.76) .220(5.59) .200(5.08) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS o Ratings at 25 C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in inches and (millimeters) SYMBOL S1A S1B S1D S1G S1J S1K S1M UNITS Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts VDC 50 100 200 400 600 800 1000 Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at TA = 75 oC IO Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum Instantaneous Forward Voltage at 1.0A DC Maximum DC Reverse Current @T A = 25 o C at Rated DC Blocking Voltage @T A = 100 o C Maximum Reverse Recovery Time (Note 3) Typical Thermaesistance (Note 2) Typical Junction Capacitance (Note 1) Operating and Storage Temperature Range Volts 1.0 Amps I FSM 30 Amps VF 1.1 IR 5.0 Volts uAmps 100 trr 2.5 RθJL 12 CJ 30 T J, T STG -65 to + 175 uSec 0 C/ W pF 0 C NOTES : 1. Measured at 1 MHz and applied reverse voltage of 4.0 volts. 2. Thermal Resistance (Junction to Ambient), 0.2x0.2in2 (5X5mm2 ) copper pads to each terminal. 3. Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A. 342 EXIT EXI BACK NEXT BACK EXIT NEXT BACK NEXT RATING AND CHARACTERISTIC CURVES (S1A THRU S1M) DC COMPONENTS CO., LTD. R 343 EXIT EXI BACK NEXT BACK EXIT NEXT BACK NEXT