ER1A DC COMPONENTS CO., LTD. R THRU RECTIFIER SPECIALISTS ER1J TECHNICAL SPECIFICATIONS OF SURFACE MOUNT SUPER FAST RECTIFIER VOLTAGE RANGE - 50 to 600 Volts CURRENT - 1.0 Ampere FEATURES * ldeal for surface mounted applications * Low leakage current * Glass passivated junction SMB ( DO-214AA ) MECHANICAL DATA .083(2.11) .075(1.91) * Case: Molded plastic * Epoxy: UL 94V-0 rate flame retardant *Terminals: Solder plated, solderable per MIL-STD-750, Method 2026 * Polarity: As marked * Mounting position: Any * Weight: 0.093 gram .185(4.70) .160(4.06) .060(1.52) .030(0.76) .220(5.59) .200(5.08) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 o C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in inches and (millimeters) SYMBOL ER1A ER1B ER1C ER1D ER1E ER1G ER1J UNITS Maximum Recurrent Peak Reverse Voltage VRRM 50 100 150 200 300 400 600 Volts Maximum RMS Voltage VRMS 35 70 105 140 210 280 420 Volts VDC 50 100 150 200 300 400 600 Volts Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at TA = 55 oC IO Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum Instantaneous Forward Voltage at 1.0A DC Maximum DC Reverse Current @T A = 25 o C at Rated DC Blocking Voltage @T A = 100 o C Maximum Reverse Recovery Time (Note 3) Typical Thermaesistance(Note 2) Typical Junction Capacitance (Note 1) Operating and Storage Temperature Range 1.0 I FSM VF Amps 30 0.95 IR Amps 1.25 5.0 1.7 Volts µAmps 100 trr 35 RθJL 10 CJ 34 T J, TSTG -50 to + 150 NOTES : 1. Measured at 1 MHz and applied reverse voltage of 4.0 volts. 2. Thermal Resistance (Junction to Ambient), 0.2x0.2in2 (5X5mm2 ) copper pads to each terminal. 3. Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A. nSec 0 C/ W pF 0 C DC COMPONENTS CO., LTD. R R1G E~E ER1 ER1 A~E R1D RATING AND CHARACTERISTIC CURVES ( ER1A THRU ER1J )