SDI-002 SERIAL D1 TO RGB MODULE + + + + Small compact design for pcb mounting 8 bit RGB output Separate mixed syncs RsGsBs (Combined sync) available. + + + Auto 625/525 operation Fully filtered outputs Reclocked SD outputs available. This interface card accepts D1 serial digits and provides all the necessary filtered analogue signals required for 8-bit monitoring on a pcb mounting module. Input Requirements Input 1 x 270 Mb/s serial NRZI (EBU TECH3267, SMPTE RP-259M) 75 ohm terminating 625/50 or 525/60 Auto detection Automatic up to 40 dB at 200 MHz (Typically 300m of Belden 8281 at 270mb/s) Input Impedance Line standard Equalisation Output Characteristics Output format Output levels Output Impedance Resolution Freq Response Noise Either RGB or RsGsBs (As requested.) 700 mV ± 1% not including syncs 75 ohms 8 bit data / 9 bit DAC < 0.3 dB to 5.5 MHz > 60 dB rms to 5.5 MHz Sync Output Characteristics Sync output amplitude Sync amp. on RsGsBs 2V± 5% into 75 ohm 300 mV ± 10 mV into 75 ohm Other parameters Power +5V ± 0.25V - 5V ± 0.50V 00C to 400C Yes DR00167A Operating Temperature Aqueous Washable Package ORDERING CODES SDI-002A SDI-002B SDI-002C SDI-002D Reclocked o/p’s x √ x √ RGB o/p √ √ x x (500 mA max) (50 mA max) RsGsBs o/p x x √ √ © Faraday Technology. As part of continual product improvement the specifications, details and dimensions shown in this publication are subject to change without notice FARA012d Page 1 of 2 Dec-99(B) PACKAGE DETAIL Faraday Technology Ltd. Croft Road Industrial Estate, Newcastle, Staffordshire ST5 0QZ. England. FARA012d Tel: Fax: Email: Web site: Page 2 of 2 + 44 (0)1782 661501 + 44 (0)1782 630101 [email protected] http://www.faradaytech.co.uk Dec-99(B)