MURS260-A SURFACE MOUNT ULTRAFAST GLASS PASSIVATED RECTIFIER VOLTAGE： ：600V CURRENT： ： 2.0A SMA／ ／DO-214AC FEATURE Ideal for surface mount pick and place application Low profile package Built-in strain relief High surge capability High temperature soldering guaranteed 260℃/10sec/at terminals Glass passivated chip Ultrafast recovery time for high efficiency MECHANICAL DATA Terminal：Solder plated, solderable per MIL-STD-750, Method 2026 Case：JEDEC DO-214AC molded plastic body over passivated chip Polarity：Color band denotes cathode Marking：M260A Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25℃, unless otherwise stated, for capacitive load, derate current by 20％) SYMBOL MURS260-A units Maximum Recurrent Peak Reverse Voltage Vrrm 600 V Maximum RMS Voltage Vrms 420 V Maximum DC blocking Voltage Vdc 600 V Maximum Average Forward Rectified If(av) 2.0 A Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load Maximum Forward Voltage atrated Forward current Maximum Reverse Recovery Time (Note 1) Ifsm 35.0 A Vf 1.45 V Trr 50 5.0 150.0 nS Maximum DC Reverse Current at rated DC blocking voltage Ta =25℃ Ta =150℃ Ir Typical Junction Capacitance (Note 2) Cj 30.0 pF Typical Thermal Resistance (Note 3) Rth(jl) 13.0 ℃/W Tj, Tstg -50 to +150 ℃ Storage and Operating Temperature µA Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHZ and applied voltage of 4.0Vdc 3. Thermal Resistance from Junction to terminal mounted on 5×5mm copper pad area Rev.A1 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES MURS260-A Rev.A1 www.gulfsemi.com