ES3A THRU ES3J SURFACE MOUNT FAST ULTRAFAST RECTIFIER VOLTAGE: :50 TO 600V CURRENT: :3.0A SMC/ /DO-214AB FEATURE Ideal for surface mount pick and place application Low profile package Built-in strain relief High surge capability High temperature soldering guaranteed 260℃/10sec/at terminals Glass passivated chip Ultrafast recovery time for high efficiency MECHANICAL DATA Terminal:Solder plated, solderable per MIL-STD-750, Method 2026 Case:JEDEC DO-214AB molded plastic body over passivated chip Polarity:color band denotes cathode Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25℃, unless otherwise stated, for capacitive load, derate current by 20%) SYMBOL ES3A ES3B ES3C ES3D ES3G ES3J units Maximum Recurrent Peak Reverse Voltage Vrrm 50 100 150 200 400 600 V Maximum RMS Voltage Vrms 35 70 105 140 280 420 V Vdc 50 100 150 200 400 600 V Maximum DC blocking Voltage Maximum Average Forward Rectified at TL =100℃ Peak Forward Surge Current 8.3ms single half sine- wave superimposed on rated load Maximum Instantaneous Forward Voltage at rated forward current 3.0A Maximum DC Reverse Current Ta =25℃ at rated DC blocking voltage Ta =100℃ Maximum Reverse Recovery Time Typical Junction Capacitance Typical Thermal Resistance (Note1 ) (Note 2) (Note 3) Storage and Operating Junction Temperature If(av) 3.0 A Ifsm 100.0 A Vf 0.90 1.25 10.0 500.0 Ir Trr 1.7 20 V µA 25 35 nS Cj 45.0 pF Rth(jl) 12.0 ℃/W Tstg, Tj -55 to +150 ℃ Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Thermal Resistance from Junction to terminal mounted on 5×5mm copper pad area Rev.A2 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES ES3A THRU ES3J Rev.A2 www.gulfsemi.com