SB180-E-41C SCHOTTKY BARRIER RECTIFIER VOLTAGE: 80V CURRENT: 1.0A FEATURE DO-41 High current capability, Low forward voltage drop Low power loss, high efficiency High surge capability High temperature soldering guaranteed 250°C /10sec/0.375" lead length at 5 lbs tension Halogen Free MECHANICAL DATA Terminal: Plated axial leads solderable per MIL-STD 202E, method 208C Case: Molded with UL-94 Class V-0 Halogen Free Epoxy Polarity: color band denotes cathode Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated) Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current 3/8" lead length Peak Forward Surge Current 8.3ms single half sinewave superimposed on rated load Inrush Current with 10Ω and 20uF foil capacitor placed in series to the DUT 10000 times, 10s between each pulse Tc=120℃ Maximum Forward Voltage at 1.0A DC Maximum DC Reverse Current Tc =25℃ at rated DC blocking voltage Tc =100℃ Tc =120℃ Maximum Reverse Recovery Time(Note 1) Tc =25℃ Tc =120℃ Total power dissipatio (Note2) Typical Thermal Resistance (Note 3) (Note 4) Storage and Operating Junction Temperature SYMBOL SB180-E-41C units Vrrm Vrms Vdc 80 56 80 1.0@ TL=100℃ 0.5@ Tc=120℃ V V V Ifsm 40.0 A Ifsm-1 40min A Vf 0.84 0.5 1.5 4.0 V If(av) Ir Trr Ptot Rth(ja) Rth(jc) Tj, Tstg A mA 2 5 840 50 30 -65 to +150 nS mW ℃/W ℃ Note: 1. 2. 3. 4. Rev.A1 Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A Tc=25℃(according to calculations) Thermal Resistance from Junction to Ambient at 0.5" lead length, vertical P.C. Board Mounted Thermal Resistance from Junction to Case www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES SB180-E-41C Rev.A1 www.gulfsemi.com ESD CAPABILITY SB180-E-41C 1. According to 1.4601.442-01 test circuit, ESD Test of SB180-E at 80 Vdc passed with the immunity capability of ±15KV 2. Description of test method & conditions Setup: Test voltages for DUT: max specified DC blocking voltage. ESD test level for Contact discharge: 10 Impulses at each test level and output polarity. Test level:±2,±4,±6,±8,±10,±12,±15KV Test criteria:No faults are allowed. Ambient temperature: 25℃ ℃ Relative humidity : 55% Specification: ESD Generator according to IEC 61000-4-2 ( 1.4601.442-01 ) Rev.A1 www.gulfsemi.com