Approved by: Checked by: Issued by: SPECIFICATION PRODUCT: SAW FILTER MODEL: HF4504D (M1967D) SIP5D HOPE MICROELECTRONICS CO.,LIMITED Tel:+86-755-82973806 Fax:+86-755-82973550 E-mail: [email protected] http://www.hoperf.com Page 1 of 1 1.Construction 1.1 Dimension and materials Type : F4504D 1.2. Circuit construction, measurement circuit 2.Characteristics Standard atmospheric conditions Unless otherwise specified , the standard rang of atmospheric conditions for making measurements and tests is as follows; Ambient temperature : 15℃ to 35℃ Relative humidity : 25% to 85% Air pressure : 86kPa to 106kPa 1 Operating temperature rang Operating temperature rang is the rang of ambient temperatures in which the filter can be operated continuously. -10℃ ~ +60℃ Storage temperature rang Storage temperature rang is the rang of ambient temperatures at which the filter can be stored without damage. Conditions are as specified elsewhere in these specifications. -40℃ ~ +70℃ +25℃ Reference temperature 2.1 Maximum Rating DC voltage VDC AC voltage Vpp 2.2 Electrical Characteristics Source impedance Load impedance Insertion attenuation Reference level Relative attenuation Sidelobe 12 10 V V Between any terminals Between any terminals ZS=50Ω ZL=2kΩ//3pF TA=25℃ Freq Min typ max 44.06MHz 10.7 12.7 14.7 dB 45.81MHz 4.5 6.0 7.5 42.23MHz -0.5 1.0 2.5 41.98MHz - 3.0 - 41.73MHZ - 7.4 - dB dB dB dB 41.31MHz 17.1 19.1 21.1 dB 39.81MHz 42.0 50.0 dB 47.31MHz 40.0 48.0 dB 35.06~39.81MHz 35.0 dB 47.31~55.06MHz 35.0 dB Impedance at 44,06 MHz Z IN = R IN || C IN Input: Output: Z OUT = R OUT || C Temperature coefficient OUT - 0,9 || 14,9 0,9 || 4,1 - κΩ || pF κΩ || pF -72 ppm/k 2.3 Environmental Performance Characteristics Item Test condition Allowable change of absolute Level at center frequency(dB) High temperature test < 1.0 70℃ 1000H Low temperature test < 1.0 -40℃ 1000H Humidity test < 1.0 40℃ 90-95% 1000H 2 Thermal shock -20℃==25℃==80℃ 20 cycle 30M 10M 30M Solder temperature test Sold temp.260℃ for 10 sec. Soldering Immerse the pins melt solder at 260℃+5/-0℃ for 5 sec. 2.4 Mechanical Test Item Test condition Vibration test 600-3300rpm amplitude 1.5mm 3 directions 2 H each Drop test On maple plate from 1 m high 3 times Lead pull test Pull with 1 kg force for 30 seconds Lead bend test 90o bending with 500g weigh 2 times 2.5 Voltage Discharge Test Item Test condition Surge test Between any two electrode < 1.0 < 1.0 More then 95% of total area of the pins should be covered with solder Allowable change of absolute Level at center frequency(dB) <1.0 <1.0 <1.0 <1.0 Allowable change of absolute Level at center frequency(dB) <1.0 3 2.6 Frequency response： 4