ETC I5062-ZD

Create
i5062-ZD
i5062-ZD
USB Flash Disk Controller
Data Sheet
iCreate Technologies Corporation
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 1
Create
i5062-ZD
© Copyright 2005 iCreate Technologies Corporation
Information contained in this publication is intended through suggestion only and may be superseded by
updates. No liability is assumed by iCreate Technologies Corporation with respect to the use of such
information or otherwise and no representation or warranty is given. Use of iCreate’s products as critical
components in life support systems is not authorized.
No part of this document may be reproduced or transmitted in any form or by any means for any purpose
without the permission of iCreate. No licenses are conveyed, implicitly or otherwise, under any intellectual
property rights. The iCreate logo and name are registered trademarks of iCreate Technologies Corporation.
All rights reserved. All other trademarks mentioned herein are the property of their respective companies.
Data sheet marking
iCreate uses various markings in the data sheet to designate each document phase as it relates to the
product development stage.
Marking
Description
Objective Specification
The objective specification contains data for new product development.
Advance Information
The information is on products in the design phase. Your designs should not be
finalized with this information.
Preliminary
This is preliminary information on new products but not yet fully characterized.
The specifications in these data sheets are subject to change in any manner
without notice.
No Marking
Information contained in the data sheet is on products in full production.
For more information, please contact:
iCreate Technologies Corporation
2F, No. 26, R&D 2nd Rd.,
Hsinchu Science Park,
Hsinchu, Taiwan 300
Phone +886-3-579-0000
Fax
+886-3-579-0077
E-Mail [email protected]
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 2
Create
i5062-ZD
1. Introduction
General description
i5062-ZD is a single-chip USB flash disk
controller which can handle up to four NANDtype flash memory chips. It is compatible with
USB 1.1 and also compliant with USB 2.0. The
features of USB-boot-up and driver-less make
the flash disk very convenient for end-users.
i5062-ZD is designed with iCreate flash
interface technology to provide wear-leveling
and on-the-fly error-correction coding, which
enhance the life time of the disk. The flexibility
of the interface design also ensures supporting
to AND flash by firmware change and MLC
NAND flash in the protocol level.
For data security, i5062-ZD supports
multi-level protection mechanism. In the nonprotection level, data in the disk is fully
accessible. In low protection level, disk is readonly to protect from virus and accidental file
removal. In high protection level, the disk data
cannot be accessed.
User-programmable device name based
on USB Mass Storage protocol (SCSI) is also
provided. The end-users can change the
device name that appears in Windows.
Features
System Function
USB 1.1 compatible and USB 2.0 compliant
USB-ZIP/USB-HDD boot-up
Support multi-disk
Multi-level security protection
Support Read-only privilege
Compatible with Windows 98/Me/2K/XP,
MacOS 9+, and Linux kernel 2.4+
Configurable Removable or Fixed drive type
under Windows
Support unique serial number for each disk
Configurable USB vendor/product ID
Support customized disk ID by end-user
Read speed > 1000K byte/s
Write speed > 800K byte/s
Write protect switch
Ready/busy LED
Flash Control
Support 128Mb to 8Gb NAND-type flash,
AND flash is supported with i5068-Z.
Connect up to four flash chips
Wear-leveling extends product life time
Defect block concealment and dynamic
defect block handling
On-the-fly ECC enhances reliability
Chip Hardware
On-chip voltage detector for power-on-reset
Single 3.3V voltage supply
6MHz external clock for low EMI
32 pin TSOP Type I package
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 1
Create
i5062-ZD
2. Pin Configuration and Definition
Pin configuration
32 PIN TSOP TYPE-I
VDDA
1
32
LED
VSSA
2
31
VSS
FD7
3
30
FCE3
FD6
4
FCE2
FD5
5
28
FCE1
FD4
6
27
FCE0
VDD
7
Create
29
26
VDDA
OSCI
8
DPLS
OSCO
9
i5062-ZD
25
24
DMNS
23
VSSA
22
VDD
21
FWEN
20
FREN
19
VDD
VSS
10
FD3
11
FD2
12
FD1
13
FD0
14
FCLE
15
18
FRDY
FALE
16
17
PPU
WYWW
E F Y M Z Z . P
(TOP VIEW)
Figure 1. Pin configuration
Pin definition
Pin Number
Name
Function
IO Type
USB (2 pins)
25
DPLS
Analog
USB bus D+.
24
DMNS
Analog
USB bus D-.
8
OSCI
Clock In
9
OSCO
Clock (2 pins)
6MHz crystal input.
Clock Out 6MHz crystal output.
Flash (17 pins)
3, 4, 5, 6, 11, FD7, FD6, FD5,
12, 13, 14
FD4, FD3, FD2,
FD1, FD0
IO4
Bi-directional data bus signals to NAND flash.
30, 29, 28,
27
FCE3, FCE2,
FCE1, FCE0
O2
Active-low chip enable signals to NAND flash.
15
FCLE
O4
Command latch enable (CLE) of NAND flash.
16
FALE
O4
Address latch enable (ALE) of NAND flash.
20
FREN
O4
Active-low read enable signal to NAND flash.
21
FWEN
O4
Active-low write enable signal to NAND flash.
18
FRDY
I, ST, PU
Ready/Busy from NAND flash.
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 2
Create
i5062-ZD
System Control (2 pins)
17
PPU
IO4
This pin controls programmable pull-up of DPLS, and is
connected to DPLS through 1.5 KΩ resistor.
32
LED
O8
This pin controls LED. LED blinks when operating and
dark when idle.
Power and Ground (9 pins)
7, 19, 22
VDD
Power
3.3V Power
10, 31
VSS
Ground
Ground
1, 26
VDDA
Power
3.3V Analog Power
2, 23
VSSA
Ground
Analog Ground
Function of I/O types
I
ST
PU
O2
O4
O8
IO4
Input
Input with Schmitt trigger
Input with internal pull-up
Output buffer with 2mA driving capability
Output buffer with 4mA driving capability
Output buffer with 8mA driving capability
I/O buffer with 4mA driving capability
3. Electrical Specifications
Recommended Operating Condition
Symbol
VDD
TOPR
Parameter
VDD Voltage
Operating temperature
Min
Typ
Max
3.0
3.3
3.6
0
70
Units
V
o
C
DC Characteristics
Symbol
Parameter
VIL
Input LOW voltage
VIH
Input HIGH voltage
VOL
Output LOW voltage
VOH
Output HIGH voltage
Min
Typ
Max
Units
0.3*VDD
V
2.0
V
0.4
2.4
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
V
V
Page 3
i5062-ZD
Create
4. Package Dimensions
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 4
Create
i5062-ZD
5. Flash Support List
Actrans
512Mbit (64MByte)
Fujitsu
128Mbit (16MByte)
Hynix
256Mbit (32MByte)
512Mbit (64MByte)
1Gbit (128MByte)
2Gbit (256MByte)
1Gbit (128MByte) Large Block
Infineon
256Mbit (32MByte)
512Mbit (64MByte)
1Gbit (128MByte)
Micron
2Gbit (256MByte) Large Block
Samsung
128Mbit (16MByte)
256Mbit (32MByte)
512Mbit (64MByte)
1Gbit (128MByte)
2Gbit (256MByte)
1Gbit (128MByte) Large Block
2Gbit (256MByte) Large Block
4Gbit (512MByte) Large Block
8Gbit (1GByte) Large Block
Sandisk
128Mbit (16MByte)
256Mbit (32MByte)
512Mbit (64MByte)
1Gbit (128MByte)
2Gbit (256MByte)
512Mbit (64MByte) 4LC
1Gbit (128MByte) 4LC
2Gbit (256MByte) 4LC
1Gbit (128MByte) Big Block
2Gbit (256MByte) Big Block
ST
128Mbit (16MByte)
256Mbit (32MByte)
512Mbit (64MByte)
1Gbit (128MByte)
AC79LV512B
MBM30LV0128
HY27US08561M
HY27US08121M
HY27UA081G1M, HY27UA081G4M
HY27UB082G4M
HY27UF081G2M
HYF33DS256800ATC
HYF33DS512800ATC
HYF33DS1G800ATC
MT29F2G08AAA
KM29U128, K9K2808U0, K9F2808U0
K9K5608U0, K9F5608U
K9K1208U0, K9F1208U
K9K1G08U0, K9T1G08U0
K9E2G08U0
K9F1G08U0
K9K2G08U0, K9F2G08U0
K9K4G08U0, K9W4G08U0
K9W8G08U0
SDTNFAH-128, SDTNGAHE0-128
SDTNFAH-256, SDTNGAHE0-256
SDTNFAH-512, SDTNGAHE0-512
SDTNFBH-1024, SDTNGBHE0-1024
SDTNGBHE0-2048
SDTNFCH-512, SDTNGCHE0-512
SDTNFCH-1024, SDTNGCHE0-1024
SDTNFDH-2048, SDTNGDHE0-2048, SDTNGCHE0-2048
SDTNGEHE0-1024
SDTNGFHE0-2048
NAND128W3A
NAND256W3A
NAND512W3A
NAND1GW3A
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 5
Create
i5062-ZD
1Gbit (128MByte) Big Block
Toshiba
128Mbit (16MByte)
256Mbit (32MByte)
512Mbit (64MByte)
1Gbit (128MByte)
2GBit (256MByte)
512Mbit (64MByte) 4LC
1Gbit (128MByte) 4LC
2Gbit (256MByte) 4LC
1Gbit (128MByte) Big Block
2Gbit (256MByte) Big Block
NAND1GW3B
TC58128FT, TC58DVAM72AF1FT
TC58256FT, TC58DVAM82AF1FT
TH58512FT, TC58512FT, TC58512TG, TC58DVM92A1FT
TH58100FT, TC58DVG02A1FT
TH58DVG12A1TGK0
TC58005FT, TC58DVM94B1FT
TC58010FT, TC58DVG04B1FT
TH58020FT, TC58DVG14B1FT , TH58DVG14B1FT
TC58NVG0S3AFT
TH58NVG1S3AFT
Release date: 03/10/2005
© 2005 iCreate Technologies Corporation
This document contains preliminary information on product but not yet fully characterized.
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 6