Low Capacity Standard Size Toggles Series S GENERAL SPECIFICATIONS FOR S100s Electrical Capacity (Resistive & Inductive Load) Power Level: Ratings Shown in the following table Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Operating Temp Range: 10 milliohms maximum 200 megohms minimum @ 500V DC 1,500V AC minimum for 1 minute minimum 30,000 operations minimum 10,000 operations minimum –10°C through +70°C (+14°F through +158°F) Materials & Finishes Toggle: Bushing: Case: Case Cover: Movable Contactor Plate: Movable & Stationary Contacts: Terminals: Brass with chrome plating Brass with chrome or nickel plating Phenolic resin Steel with zinc plating Copper with silver plating Silver alloy plus copper with silver plating Copper with silver plating Installation Mounting Torque: Soldering Time & Temperature: 2.94Nm (26 lb•in) for double nut Manual Soldering: See Profile A in Supplement section. Standards & Certifications CSA Certified: Certified at 5A @ 125V AC & 2A @ 250V AC; CSA File No. 023535-0-000. Add “/C” to end of part number to order CSA mark on switch. S114, S116, & S116R Electrical Capacity Toggle Position/Connected Terminals Down Model Approvals Pole & Throw Center Resistive Up Keyway Inductive AC 125V AC 250V DC 30V AC 125V PF 0.6 Angle of Throw S114 — DPST ON 2-1 5-4 NONE OFF — 5A 2A 5A 3A 25° S116 — DPDT ON 2-1 5-4 NONE ON 2-3 5-6 5A 2A 5A 3A 25° S116R — DPDT ON 2-1 5-4 NONE ON 2-3 5-6 5A 2A 5A 3A 25° Throw & Schematics: — 2 DPST 1 2 5 (COM) (COM) 5 DPDT 1 4 3 6 4 Note: Terminal numbers are actually on the switch • Standard Hardware: AT504M Knurled Nut, AT508 Lockwasher, AT527M Backup Hex Nut. See Accessories & Hardware section. S114 & S116 (2.0) Dia Typ .079 M12 P1 Keyway (6.0) Dia .236 S116 (9.0) .354 (10.35) Typ .407 25° (17.6) .693 S116R Black Polyamide Paddle (5.5) .217 (18.0) .709 (10.0) .394 (22.9) .902 (4.0) .157 (2.3) Dia .090 (3.8) Typ .150 6 3 5 2 4 1 (12.5) Dia .492 (11.5) .453 (27.8) 1.094 (1.5) .060 (0.8) Typ .031 (4.0) .157 (29.0) 1.142 (0.3) Typ .012 S114 does not have terminals 3 & 6 Maximum Panel Thickness: .158” (4.0mm) NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07