Oscilent Corporation IF SAW Filter | 820-IF87.2M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 820-IF87.2M-A 20.18 x12.58mm Base Station & Repeater Apr 18, 2007 TYPE : 87.2 MHz Bandpass Filter PART NUMBER : 820-IF87.2M-A Frequency Response OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 87.14 87.20 87.26 MHz Insertion Loss - 20.5 24.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth 1.0 dB - 7.6 - MHz Bandwidth 3.0 dB 7.8 8.0 - MHz Bandwidth 40.0 dB - 9.7 9.8 MHz Passband Ripple (Fo +/- 3MHz) - 0.5 1.0 dB Group Delay Variation - 70 150 nsec Absolute Delay - 2.28 - µsec Substrate Material - LN - - Ambient Temperature - 25 - °C 50 55 - dB Center Frequency Ultimate Rejection *Custom parameters available. Contact Oscilent Sales for discussion. PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 820-IF87.2M-A Page 2 of 2 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 820-IF87.2M-A