Model 6491 Modular Passive Oscilloscope Probe Accessories included with Probe: Model 6491 Modular Passive Oscilloscope Probe Features • • • • USA: This probe is recommended for general purpose probing applications and is adjustable for high frequencies. Our passive probes are spring loaded, with needle sharp tips to support precise and safe measurements. Probe tips are interchangeable and can be replaced easily. Accessories (one of each) included with Probe are: BNC Adapter Ground Blade Ground Lead with Alligator Clip 22 cm (8.66”) IC Caps: 0.8mm, 1.0mm, and 1.27mm pitch Insulating Cap (red) Protection Cap Solid Tip 0.8mm (0.0315”) Spring Tip 0.8mm (0.0315”) Sprung Hook Trimmer Tool 2 Footer Positioner Copper (Cu) Pads Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com Specifications Attenuation Ratio Maximum Input Voltage CAT II¹ Scope Bandwidth MHz Probe Bandwidth MHz (-3 dB) System Risetime (ns) Probe Input Resistance (MΩ) Probe Input Capacitance (pF) Cable Length 1:1 55 Vrms 60 30 < 12 1 < 39.5 4 ft. (1.2 m) 1 Rating: Per IEC 61010-031. Maximum voltage allowed on the low or ground connection including shell and housing must not exceed 30 V. Ordering Information Model: 6491 30 MHz X1 Oscilloscope Probe All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright © 2008 D1094821 Rev. 100 Page 1 of 1