Model 73023 MMCX PLUG STRAIGHT CRIMP, RG174, 316 Model 73023 MMCX PLUG STRAIGHT CRIMP, RG174, 316 Snap-on coupling and microminiature size for fast connect and disconnect where space is limited Features • DC - 3 GHz bandwidth. • 50% smaller than MCX connectors. • Connectors allow rotation of 360˚ for layout flexibility. • Non-slotted contact design for low RF leakage. • Meets CECC 22340. • Perfect for applications where space, weight, performance and ease of assembly are required. Materials • • • • Body is machined brass with gold plating. Center contacts – Plug is gold plated Phosphor bronze and Jack is gold plated beryllium copper. High quality PTFE insulators. Crimp Ferrules are gold or nickel plated copper. Ordering Information Specifications Impedance 50 Ω Frequency Range DC - 3 GHz Working Voltage 170 Vrms max. at sea level Dielectric Withstanding Voltage 500 Vrms VSWR 1.35 max. Center / Outer contact resistance 10 / 5 mΩ Number of insertions 500 cycles minimum Insulation resistance > 500 MΩ Temperature Range -55˚ C to 155˚ C, -67˚ F to 311˚ F Model: 73023 Description: MMCX PLUG STRAIGHT CRIMP, RG174, 316 USA: Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (.51 mm), .xxx = ± .005” (.127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. D2003455 REV 001 Copyright © 2007 12/15/2007 Page 1 of 2 Model 73023 MMCX PLUG STRAIGHT CRIMP, RG174, 316 Cable Types and Crimp Die Information Connector Model # Cable Groups 73023 RG174, 316 Crimp Die Cavity Size for Outer Ferrule .128 (3.3) . Cable Assembly Instructions USA: Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (.51 mm), .xxx = ± .005” (.127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. D2003455 REV 001 Copyright © 2007 12/15/2007 Page 2 of 2