HPA Module RFP-0880-42-27 Product Features Application • Solid-state linear design • Small and light weight • Suitable for CDMA • 50 Ohm Input/Output impedance • High reliability and ruggedness • Built in Output Isolator • Built in monitoring circuit • High efficiency • CDMA Repeater Description This HPA Module is a high gain, wide dynamic range amplifier module. It has superior performance comes with a modest price tag. Custom design available. Electrical Specifications @ VDD=+27VDC, T=25°C, 50Ω System PARAMETER Symbol Specification Frequency Range BW 875 ~ 890MHz Output Power P 42dBm/4FA (CDMA) In-Band Spurious Emissions SE Fo±750KHz ≤-48dBc (min) Fo±1.98MHz ≤-63dBc (min) @27Volt RBW 30KHz (@9CH CDMA Po=42dBm_4FA) RF Gain G 50dB ±1dB @frequency range, +27V, Gain Flatness ΔG ±0.5dB peak to peak Gain Variation Over Dynamic Range ΔGTEMP ±0.5dB max. @ Po=+20dBm~+42dBm(△Pin:-22dB), 27V, +25℃ Normal Operating Voltage VDC +27V ±1V Input Return Loss S11/S22 -18dB min. Mismatch Protected with Isolator Output Protection (Over temp. & Voltage & Power, Output mismatch) Harmonics (2nd) H Current Consumption IDD Operating Temperature OT -20℃ ~ + 70℃(CASE TEMP) Over power shutdown OPS 47dBm±0.5dB Detect Accuracy Impedance -45dBc min. 5.5A max. @+27V, +25℃, Po=+42dBm 0.5A max. @ ’DISABLE’ state ±0.5dB Po=+21dBm~+42dBm ±1dB Po=+0dBm~+10dBm 50Ω ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0 HPA Module RFP-0880-42-27 Interface Connectors 1. GND 2. Over Power alarm 6~10sec delay shutdown@45dBm, immediately shutdown@47dBm (TTL=HIGH) 3. VSWR alarm Output Port open, Pout >31dBm (TTL=HIGH) Alarms/ 4. NC Enable : TTL Low & GND / Disable : TTL High & Open Interface 5. Over Temp. Alarm D-Sub, 9-Pin & Shutdown 6. Enable/Disable 90℃±5℃(shutdown), 70℃±5℃(auto recovery) TTL High Alarm Enable : TTL Low & GND / Disable : TTL High & Open 7. NC 8. Power monitor 4V@42dBm_4FA / [0.1V/dBm] 9. NC Connectors Physical dimension INPUT [SMA/Female] OUTPUT [N-Type/Female] 185 X 170 X 26(mm) (L X W X H) in mm OUTLINE DRAWING RF IN PWR NC GND +27V I/O P/N : RFP-0880-42-27 1 2 3 4 5 6 7 8 9 GND O / PWR V.S.W.R N.C O / TEMP ON / OFF N.C PWR MON N.C I/O RF OUT Removal ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0 HPA Module RFP-0880-42-27 TYPICAL PERFORMANCE S11 Gain & Gain Flatness S22 Spurious Emissions(Lower) Output Power Spurious Emissions(Upper) RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0