DTC114TE/DTC114TUA/DTC114TKA DTC114TCA/TC114TSA Elektronische Bauelemente NPN Digital Transistors (Built-in Resistors) FEATURES * Built-in bias resistors enable the configuration of an inverter circuit without connecting input resistors * Only the on/off confitions need to be set for operation, making device design easy. * The bias resistors consis of thin-film resistors with compete isolation to allow negative biasing of the input. They also have the advantage of almost completely eliminating parasitic effects. PIN CONNENCTIONS AND MARKING DTC114TE SOT-523 DTC114TUA (1) Base (1)(1) Base Base (2) Emitter (2)(2) Emitter Emitter (3) Collector (3)(3) Collector Collector SOT-323 Abbreviated symbol: 04 DTC114TKA (1) Base Abbreviated symbol: 04 DTC114TCA DTA114ECA (1) Base (1) Base (2) Emitter (2) Emitter (3) Collector (3) Collector (2) Emitter (3) Collector SOT-23-3L SOT-23 Abbreviated symbol:04 Abbreviated symbol: 04 DTC114TSA (1) Emitter (2) Collector (3) Base TO-92S http://www.SeCoSGmbH.com 01-Jun-2002 Rev. A l Any changing of specification will not be informed individua Page 1 of 2 DTC114TE/DTC114TUA/DTC114TKA DTC114TCA/TC114TSA Elektronische Bauelemente NPN Digital Transistors (Built-in Resistors) MAXIMUM RATINGS* TA=25℃ unless otherwise noted Symbol LIMITS(DTC114T□) Parameter E UA KA Units CA SA VCBO Collector-Base Voltage 50 V VCEO Collector-Emitter Voltage 50 V VEBO Emitter-Base Voltage 5 V IC Collector Current -Continuous 100 mA PC Collector Dissipation Tj Junction temperature TJ, Tstg Junction and Storage Temperature 150 ELECTRICAL CHARACTERISTICS (Tamb=25℃ Parameter unless 200 300 mW 150 ℃ -55~+150 ℃ otherwise Symbol Test Collector-base breakdown voltage V(BR)CBO Ic=50µA,IE=0 50 V Collector-emitter breakdown voltage V(BR)CEO Ic=1mA,IB=0 50 V Emitter-base breakdown voltage V(BR)EBO IE=50µA,IC=0 5 V Collector cut-off current ICBO VCB=50V,IE=0 0.5 uA Emitter cut-off current IEBO VEB=4V,IC=0 0.5 uA DC current gain hFE VCE=5V,IC=1mA VCE(sat) IC=10mA,IB=1mA Collector-emitter saturation voltage Transition frequency fT Imput resistor R1 conditions specified) MIN 100 TYP 300 MAX 600 0.3 VCE=10V,IE=-5mA, f=100MHz 250 7 10 UNIT V MHz 13 kΩ Typical Characteristics http://www.SeCoSGmbH.com 01-Jun-2002 Rev. A Any changing of specification will not be informed individua Page 2 of 2