622 Mbps SFP Transceiver SP-12-IR1 Features • Compliant with OC12/STM-4 Standards • Single 3.3 V supply • 13 dB min. link budget • 1310nm FP Laser, 15 km reach • SFP MSA SFF-8074i compliant • Bellcore GR-468 compliant • Color coded bail latch: Gray • RoHS-5/6 compliant product (lead exemption) • Digital Diagnostic SFF-8472 Compliant General operating Parameter Supply Voltage Total Current Symbol Min. Typical Max. Unit Vcc 3.135 3.3 3.465 V Icc - - 300 mA Power Supply Noise Rejectiona PSR 100 - - mVp-p Operating Temperature (-CXX) Top -5 - 70 ºC Operating Temperature (-TXX) Top -40 - 85 ºC Storage Temperature Tst -40 - 85 ºC Data Rate OC12/STM-2 DR - 622 - Mbps Symbol Min Typical Max Unit POP -15 -11 -8 dBm Average Launch Power Of Off Tx POff - - -30 dBm Extinction Ratio ER 8.2 - - dB - - - SONET/SDH compliant a) 20Hz to 155MHz Transmitter Specifications Parameter Optical Power Eye Mask Optical Jitter Generation Jgen - - 0.002 UI Optical Rise Timeb tr - - 500 ps Optical Fall Timeb tf - 500 ps λ 1274 1310 1356 nm ∆λ - - 2.5 nm - 0.5 1 dB - - -120 dB/Hz Mean Wavelength Spectral Width (RMS) Dispersion Penalty (at 15 Km) Relative Intensity Noise RIN b) 20%-80% values LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1500-Oct3105 Rev A.0 622 Mbps SFP Transceiver SP-12-IR1 Transmitter Specifications (Electical) Parameter Input Differential Impedence PECL Single Ended Data Input Swing TxFault_Fault TxFault_Normal Symbol Min Typical Max Rin 80 100 120 Unit Ω Vin,p-p 250 - 1200 mV Vfault 2 - Vcc V Vnormal Vee - Vee+0.5 V TxDisable_Disable Vd 2 - Vcc V TxDisable_Enable Ven Vee - Vee+0.8 V Parameter Symbol Min Typical Max Unit Receive Power Lowc Rsens,low - -30 -28 dBm Receive Power High Rsens,high -8 - - dBm Damage Threshold For Receiver Pin,damage 0 - - dBm λ 1260 1310 1360 nm -38 - - dBm LOS De-assert - - -28 dBm LOS Hysteresis 0.5 - - dB Receiver Specifications Wavelengthd LOS Assert 10-12 c) at nominal wavelength d) Operational over 1200 to 1625 nm range Electrical Output Parameter Symbol Min Typical Max Unit PECL Single Ended Data Output Swing Vout, p-p 185 - 800 mV Data Output Rise Time tr - - 500 ps Data Output Fall Time tf - - 500 ps Timing and Electrical Parameter Symbol Min Typical Max Unit t_on - - 1 ms Tx Disable Assert Time t_off - - 10 µs Time To Initialize, Including Reset Of Tx Fault t_init - - 300 ms Tx Disable Negate Time Tx Fault Assert Time t_fault - - 100 µs Tx Disable To Reset t_reset 10 - - µs t_loss_on - - 100 µs Los De-assert Time t_loss_off - - 100 µs Serial ID Clock Rate f_serial_clock - - 100 KHz 2 - - V Los Assert Time RX_LOS Voltage (High) RX_LOS Voltage (Low) LOS Output Voltage-Fault LOS Output Voltage-Normal - - 0.8 V VLOS fault 2 - Vcc V VLOSnormal Vee - Vee+0.5 V MOD_DEF (0:2)-High Vh 2 - Vcc V MOD_DEF (0:2)-LOW Vl Vee - Vee+0.5 V LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1500-Oct3105 Rev A.0 622 Mbps SFP Transceiver SP-12-IR1 Diagnostics Range Accuracy Unit Calibration Temperature (-CDA) -5 to 70 ±3 ºC Internal Tc(C)=Tad(16 bit signed twos complement)/256 Temperature (-TDA) -40 to 85 ±3 ºC Internal Tc(C)=Tad(16 bit signed twos complement)/256 Voltage 0 to Vcc ±0.1 V Internal V(Volts)=Vad(16 bit unsigned integer)*0.1 Bias current 0 to 120 ±5 mA External I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX Power -15 to -8 ±3 dB dBm External TX_PWR(µW)=TX_PWRslope*TX_PWRad(16 bit unsigned integer) +TX_PWRoffset RX Power -28 to -8 ±3 dB dBm External RX_PWR(µW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Parameter Formula EEPROM Serial ID Name of Field Vendor Name Vendor OUI Vendor PN LUMINENTOIC.COM Description of Field Address Hex 20 4C L 21 55 U 22 4D M 23 49 I 24 4E N 25 45 E 26 4E N 27 54 T 28 4F O 29 49 I 30 43 C 37 00 38 06 39 B5 40 53 S 41 50 P 42 31 1 43 32 2 44 49 I 45 52 R 46 31 1 47 43 C 48 4E N 49 41 A SFP Vendor name(ASCII) IEEE vendor OUI code for LuminentOIC Inc. Part number in ASCII, e.g. SP-12-IR1-CNA ASCII 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1500-Oct3105 Rev A.0 622 Mbps SFP Transceiver SP-12-IR1 Pinout Definitions Pin Function Notes 1 VeeT TX Ground 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX Ground 15 VccR RX Power 16 VccT TX Power 17 VeeT TX Ground 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX Ground LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1500-Oct3105 Rev A.0 622 Mbps SFP Transceiver SP-12-IR1 Suggested Transceiver Interface 1�H Vcc 10�F 1�H 0.1�F VCCT .01�F Protocol IC LuminentOIC SFP 10K� R1 TX_DISABLE TX_DISABLE TX_FAULT TX_FAULT TD + SerDes Laser Driver .01�F 100� TD VEET .01�F VCCR 10�F 0.1�F RD + Receiver Amplifier .01�F 100� RD - RX_LOS RX_LOS Vcc R VEER 1 R1 R1 .01�F EEPROM R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R1=4.7K to 10K� LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1500-Oct3105 Rev A.0 622 Mbps SFP Transceiver SP-12-IR1 Outline drawing Units in mm Section A-A LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1500-Oct3105 Rev A.0 622 Mbps SFP Transceiver SP-12-IR1 Ordering Information Available Options: SP-12-IR1-CNA SP-12-IR1-CDA SP-12-IR1-TNA SP-12-IR1-TDA Part numbering Definition: SP - 12 - IR1 - Temperature Diagnostic Revision • SP = Small Form Pluggable 12 = OC12, 622 Mbps IR1 = Intermediate Reach 15 km • Operating Temperature C = Commercial (-5 to 70ºC) T = Industrial (-40 to 85ºC) • D = Digital Diagnostic N = No Digital Diagnostic • Design Revision Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS1500-Oct3105 Rev A.0