HCMOS/TTL SURFACE-MOUNT PROPROGRAMMABLE GRAMMCOMPATIBLE ABLE CRYSTAL CLOCK OSCILLATOR Pb RoHS Compliant AP5S 5.0 x 3.2 x 1.2mm | | | | | | | | | | | | | | | FEATURES: • Performance comparable to fixed frequency oscillator • Lowest peak-to-peak jitter • Low supply current • Alternative to long lead-time XO's ELECTRICAL SPECIFICATIONS: 3.3V, 2.5V OPERATION Characteristics Frequency Range 3.3V 2.5V Operation Temp. Range (See Options) Storage Temp. Range (See Options) Overall Frequency Stability * (See Options) Input Voltage (Operating Vdd) Input Current 3.3V 2.5V Symmetry at 1/2 Vdd Rise and fall time (Tr/Tf)** Output Voltage VOH VOL Start-up Time Unit MHz MHz °C °C ppm V V mA mA % nSec Minimum 10 10 0 -55 -100 2.97 2.25 --- Typical -----3.3 2.5 --- 45 -- 50 2.5 V V msec --Vdd-0.4min --0.4V max --10 pin 1 : High or Open , pin 3 : Enable pin 1 : Low , pin 3 : Disable --70 --2.5 CMOS Tri-state Function (Input to pin 1) Jitter peak-to-peak Phase Jitter (RMS, 12kHz to 20MHz) Output Type For Small Quantities, Delivery Time is 1-5 days pSec pSec -- Maximum 200 166 +70 125 100 3.63 2.75 30 20 55.0 3.5 * Inclusive of calibration @25°C, operating temperature range, input voltage variation, load variation, aging, shock, and vibration. ** Transition times are measured between 10% and 90% of Vdd with an output load of 15 pf. OPTIONS & PART IDENTIFICATION: (Left blank if standard) Supply Voltage Blank* 3.3 V 1 2.5 V *3.3V : Standard AP5S -Frequency- - - Operating Temp. 0°C to +50°C I -10°C to +60°C D -20°C to +70°C E -30°C to +70°C F -30°C to +85°C N -40°C to +85°C L Freq. Stability J(**) ±20ppm R ±25ppm K ±30ppm H ±35ppm B ±40ppm C ±50ppm Blank T Packaging Bulk Tape and Reel (* *) Available for I, D, or E temp options only. Contact ABRACON for EJ or LR options. (Availability limited) TEST CIRCUIT: Revised: 1.04.08 ABRACON IS ISO 9001 / QS 9000 CERTIFIED 30332 Esperanza, Rancho Santa Margarita, California 92688 tel 949-546-8000 | fax 949-546-8001 | www.abracon.com HCMOS/TTL SURFACE-MOUNT PROPROGRAMMABLE GRAMMCOMPATIBLE ABLE CRYSTAL CLOCK OSCILLATOR Pb RoHS Compliant AP5S 5.0 x 3.2 x 1.2mm | | | | | | | | | | | | | | | OUTLINE DRAWING: Dimensions: inch (mm) Dimensions: Inches (mm) PIN #1 #2 #3 CONNECTION OE GND/CASE OUTPUT #4 VDD Note: It is recommended to use an approximately 0.01uF bypass capacitor between PIN 2 and 4. TAPE & REEL: Dimensions: mm Revised: 1.04.08 ABRACON IS ISO 9001 / QS 9000 CERTIFIED 30332 Esperanza, Rancho Santa Margarita, California 92688 tel 949-546-8000 | fax 949-546-8001 | www.abracon.com