S339P Semiconductor Quad Voltage Comparator Description The S339 consists of four independent voltage comparators designed to operate from a single power supply over a wide voltage range. Features • • • • • • • • Single Supply Operation: 2V to 36V. Dual Supply Operation: ±1V to ±18V. Allow Comparison of Voltages Near Ground Potential. Low Current Drain 800uA Typ. Compatible with all Forms of Logic. Low Input Bias Current: 25nA Typ. Low Input Offset Current: ±5nA Typ. Low Offset Voltage: ±1mV Typ. Applications • Transducer amplifier • DC gain blocks • Conventional operational amplifiers Ordering Information Type NO. S339P Marking Package Code S339P DIP-14 Outline Dimensions unit : mm Block Diagram A KSI-L009-002 1 S339P Absolute maximum ratings Characteristic Symbol Ratings Unit Supply voltage VCC 36 or ±18 V Differential input voltage VIND 36 V Input voltage VIN -0.3 ~ +36 V Power Dissipation PD 570 mW Operating temperature Topr -40 ~ +85 °C Storage temperature Tstg -65 ~ 150 °C Electrical Characteristics (Unless otherwise specified. VCC = 5V and –40 °C ≤ Ta ≤ +85 °C) Characteristic Symbol Test Condition VO = 1.4V, Rs = 0Ω Min. Typ. Max. Unit - ±2 ±5 mV - - ±5 ±50 nA IIB - - 25 250 nA Input Common Mode Voltage Range VICR - 0 - VCC –1.5 V Supply Current ICC VCC = 5V, RL = ∞, All Channel - 0.8 2 mA Large Signal Voltage Gain AV VCC = 15V , RL = 15 KΩ - 200 - V/mV Output Voltage (‘L’ Level) VSAT VIN+= 0V, VIN-= 1V ISINK≤ 4mA - 130 400 mV Response Time tRES VRC = 5V, RL = 5.1KΩ - 1.3 - uS Output Sink Current ISINK VO≤1.5V, VIN+ = 0V, VIN- = 1V 6 16 - mA Output Leakage Current ILeak VO = 5V VIN+ = 1V, VIN- = 0V - 0.1 - nA Input Offset Voltage VIOS Input Offset Current IIOS Input Bias Current KSI-L009-002 2 S339P Electrical Characteristic Curves Fig. 1 VCC-ICC Fig. 2 VCC-IIB Fig. 3 VOL-ISINK Fig. 4 PD-Ta Fig. 5 VIN,VOUT-trsp Fig. 6 VIN,VOUT-trsp Ω Ω KSI-L009-002 3 S339P These AUK Corp. products are intended for usage in general electronic equipment (Office and communication equipment, measuring equipment, domestic electrification, etc.) Please make sure that you consult with us before you use these AUK products in equipm- ents which require high quality and/or reliability, and in equipments which could have major impact to the welfare of human life(atomic energy control, airplane, spaceship, traffic signal, combustion central, all types of safety device, etc.) AUK cannot accept liability to any damage which may occur in case these AUK products were used in the mentioned equipments without prior consultation KSI-L009-002 4