BEL APC78106

ADSL CPE Hybrid
APC78106
OPERATING TEMPERATURE -40°C TO +85°C
FEATURES
•
APC78106 is designed to interface with Alcatel’s MTK20150 and MTK20141 ADSL
transceiver chip sets to optimize customer premises equipment (CPE) designs. The
Hybrid contains every component required between the analog front end chip and the connector including
the line interface transformer and common mode chokes, line protection circuitry, transmit and receive filters
(excluding line driver and parallel capacitors).
•
The hybrid was designed jointly by APC and Alcatel to optimize the transmission capabilities of the
“Dynamite” chip set. It meets or exceeds the requirements of the standards as specified in TS101 388,
T1.413 and ETR328. It also provides BS EN60950 / IEC60950 / TS 001 / AS/NZS 3260 / CAN/
CSA C22.2 Np. 950-95 / UL1950 and CB Certificate supplementary insulation and UL Component
Recognition (File No. E175058).
SCHEMATIC
Pin
(1-2)
TNV
Pin 9
Rxn
Pin
(3-16)
SELV
Pin 10
8016 pin 4 / EL1510CS pin 3
Pin 1
Tip
Pin 11
8016 pin 2 / EL1510CS pin 1
Pin 2
Ring
Pin 12
8016 pin 3 / EL1510CS pin 2
Pin 3
Txp
Pin 13
N/C
Pin 4
Txn
Pin 14
8016 pin 21 / EL1510CS pin 5
Pin 5
A_Gnd_Tx
Pin 15
8016 pin 23 / EL1510CS pin 7
Pin 6
N/C
Pin 16
8016 pin 22 / EL1510CS pin 6
Pin 7
Hybrid Gnd
Plane
Pin 17
N/C
Pin 8
Rxp
Pin 18
N/C
NOTES:
ADI 8016 LINE DRIVER = 24 LEAD BATWING
ELANTEC EL1510CS LINE DRIVER = 8 PIN SO
1. ALL TRACES BETWEEN APC PINS 10 AND 14 AND ADI LINE DRIVER PINS 4 AND 21 RESPECTIVELY, MUST BE KEPT SYMMETRICAL, PARALLEL AND EQUIDISTANT.
2. TWO 4.7NF PARALLEL CAPACITORS SHOULD BE PLACED BETWEEN ADI LINE DRIVER PIN 4 AND AGT (A_GND_TX) AND BETWEEN ADI LINE DRIVER PIN 21 AND AGT
(A_GND_TX). THESE NEED TO BE PLACED AS CLOSE TO THE ADI LINE DRIVER AS POSSIBLE.
SAFETY NOTE:
THE CIRCUIT ON THE LC SIDE OF THE TRANSFORMER IS A SELV CIRCUIT AND THE CIRCUIT ON THE LINE SIDE OF THE TRANSFORMER IS A TNV CIRCUIT.
- CIRCUITRY DESIGNATED AS SELV SHALL ONLY BE CONNECTED TO OTHER SELV CIRCUITS (UNDER NORMAL AND SINGLE FAULT CONDITIONS) IN END
INSTALLATION
- DO NOT PLACE HYBRID AGAINST OTHER COMPONENT PARTS ATTAINING EXCESSIVE TEMPERATURES.
MECHANICAL
51.26
33
48.26
33.02
1
9
29.7
12
5.4
NOTES:
NOT TO SCALE
TOLERANCE +/- 0.2MM
ALL DIMENSIONS IN MM
PIN DIA. 0.75MM MAX.
18
10
2.54
©2003 Bel Fuse Inc. Specifications subject to change without notice. 05.20.03
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com
Page 1