CVS575 Voltage Controlled SAW Oscillator 3.3V LVPECL 5x7.5mm SMD Model CVS575 is a SAW(surface acoustic wave) based Voltage Controlled Oscillator (VCSO) designed for High Performance PLLs. It is an ideal choice for Telecommunication applications needing to meet Low Jitter generation requirements. It is housed in the industry standard 5x7.5x2.5mm SMD package. The Enable/Disable function was designed to be used with CMOS logic levels for ease of interfacing. It is not necessary to convert to LVPECL logic to turn the Ouput ON and OFF. Rev.: D Date: 06-11-07 CVS575 Performance Specification Min. Absolute Pulling Range ±50 Nominal Frequency: Customer Specified Frequency Stability 315 Linearity Max 1000 ±150 MHz ppm % +275 Output Phase Noise Units ppm ±15 Tuning Sensitivity, Kv ppm/V @1KHz Offset -100 dBc/Hz @100KHz Offset -138 dBc/Hz @10KHz Offset -125 @1MHz Offset Jitter Typ. dBc/Hz -140 @10MHz Offset 0.18 0.12 Volt. Cntrl. dBc/Hz 2 E/D 3 GND pS,RMS pS,RMS 4 OUT 5 COUT 6 Vdd Rise/Fall Times, tr/tf 20-80% 100 240 pS Output Low Voltage, VOL 1.745 V Output High Voltage, VOH 2.215 Enable High Voltage, VIH 2.0 Disable Low Voltage, VIL Enable High Current, IIH Enable Low Current, IIL Duty Cycle Supply Voltage Supply Current, Icc Control Voltage Input Impedance Input Modulation Operating Temp. Storage Temp. Parameter Mechanical Shock Mechanical Vibration Solderability Resistance to Solvents 2.420 1.470 VCC GND 45 3.0 0 -20 -45 0.8 +150 50 3.3 82 100 500 -150 55 3.6 3.3 +70 +90 Pad Connection 1 dBc/Hz -142 SONET OC-48 (12KHz-20MHz) SONET OC-192 (50KHz-80MHz) Voltage Controlled SAW Oscillator 3.3V LVPECL 5x7.5mm SMD V V V uA uA % V mA V Kohm KHz °C °C Conditions MIL-STD-883, Method 2002 MIL-STD-883, Method 2007 MIL-STD-883, Method 1014 MIL-STD-883, Method 2016 Rev.: D Date: 06-11-07