RUST 50ns ULTRA-FAST RECOVERY HIGH VOLTAGE RECTIFIER DIODES PIV to 10,000 Volts 50ns ultra-fast recovery Small size Exceptionally low leakage High surge capability Avalanche characteristics PRV 8 KV 10KV EDI SERIES RUST2008 RUST2010 ELECTRICAL CHARACTERISTICS (at TA=25 o C Unless Otherwise Specified) o Average Rectified Forward Current @ 50 C, I O (Fig1) 100 mA Max. Peak Surge Current, I FSM (8.3ms) (Fig.2) 5 Amp Max. Reverse Recovery, Trr , Fig.4 50ns Max. Forward Voltage Drop @ 100 mA, V F 26 Volts o Max. DC Reverse Current @ PRV and 25 C, IR o Max. DC Reverse Current @ PRV and100 C, I R 1 25 A A Ambient Operating Temperature Range, TA -55 to +150 o Storage Temperature Range, TSTG -55 to +150 o C C NOTES: 1.It is recommended that a proper heat sink be used on the terminals of this device between the body and soldering point to prevent damage from excess heat. 2.If operated over 10,000v/inch in length, devices should be immersed in oil or re - encapsulated. EDI reserves the right to change these specifications at any time without notice. RUST FIG.1 FIG.2 OUTPUT CURRENT vs AMBIENT TEMPERATURE NON- REPETITIVE SURGE CURRENT 0.1SEC % MAXIMUM SURGE % RATED FWD CURRENT 1.0SEC 100 100 75 50 25 75 50 25 0 0 0 25 50 75 100 125 1 150 2 3 4 O AMBIENT TEMPERATURE ( C) 5 6 7 8 9 10 20 30 40 50 60 CYCLES(60 Hz) FIG.3 A LEAD DIA. MECHANICAL Leads - solid silver A D C MIN. B INCHES MM 0.02 0.5 B 0.60 15.2 C 0.50 12.7 D 0.16 4.0 TEST CIRCUIT FIG.4 TYPICAL REVERSE RECOVERY WAVEFORM Trr R1 50 OHM D.U.T. + I F=20MA ZERO REFERENCE - PULSE GENERATOR R2 1 OHM SCOPE I R=40MA I RR =10MA R1, R2 NON-INDUCTIVE RESISTORS PULSE GENERATOR-HEWLETT PACKARD 214A OR EQUIV. IKC REP.RATE, 10 SEC. PULSE WIDTH ADJUST PULSE AMPLITUDE FOR PEAK IR ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected] * Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828