PER FAST RECOVERY SINGLE-PHASE FULL-WAVE BRIDGE 4.0 AMPERES FOR P.C. BOARD MOUNTING ne po m co he c. t er in nd ies, u n or itio orat n g b co a re r s L s te rite ica erw d n d ki n ar o f U m i s am Th ogr pr PRV/leg Type No. nt 50V 100V 200V 400V 600V 800V 1000V PER05 PER10 PER20 PER40 PER60 PER80 PER100 ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unl es s Oth erw ise Spe ci fie d) Max. Reverse Recovery , Trr (Fig.3) 200 Nano Sec. Max. Forward Voltage Drop, VF =1.3 V @ IF = 2.0 Amp Max. DC Reverse Current @ PRV and 25 o C, IR 5 Max. Peak Surge Current, IFSM (8.3 ms)(Fig.2) 100 A Amp Ambient Operating Temperature Range,TA -55 to +150 o Storage Temperature Range, TSTG -55 to +150 o Thermal Resistance (Total Bridge), R0- j-c 7.0typ. C C o C/ W NOTE: O Maximum lead and terminal temperature for soldering, 3/8 inch from case, 5 seconds at 250 C. EDI reserves the right to change these specifications at any time without notice. FIG.1 CURRENT DERATING FIG.2 NON- REPETITIVE SURGE CURRENT 5.0 0.1SEC 1.0SEC 100 BRIDGE OUTPUT RES. IND. LOADS 4.0 % MAXIMUM SURGE IF(AV). AVERAGE FORWARD CURRENT (AMP) PER 3.0 2.0 1.0 75 50 25 0 1 0 0 25 TA 50 75 100 125 2 3 4 5 6 7 8 9 10 20 30 40 50 60 CYCLES(60 Hz) 150 O = AMBIENT TEMPERATURE ( C) FIG.3 TEST CIRCUIT T RR R1 50 OHM ZERO PULSE GENERATOR - 1.0A D.U.T. + REFERENCE 0.5A R2 1 OHM 0.25A SCOPE R1, R2 NON-INDUCTIVE RESISTORS PULSE GENERATOR - HEWLETT PACKARD OR EQUIV. IKC REP.RATE, 10 SEC. PULSE WIDTH ADJUST PULSE AMPLITUDE FOR PEAK IR CASE STYLE FOR PER .52 MAX. .69 MAX. ED PE I + R AC - 1.0MIN. _ . 0 1 0 T Y P. .150 + _ .250 +.015 .051 DIA. LEADS All dimensions in inches ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected] * Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828