HAMAMATSU H7844

PHOTOSENSOR MODULE
WITH THERMOELECTRIC COOLER
H7844
Reduces dark current to 1/50 that at room temperature
after only 3 minutes of cooling
The H7844 is a photosensor module consisting of a newly developed high
sensitivity side-on photomultiplier tube, a high-voltage power supply circuit and a thermoelectric cooler. Cooling is super-efficient in the H7844
because the thermoelectric cooler is directly coupled to the photocathode
of the photomultiplier tube. This also drastically reduces thermal noise
(thermal electrons) emitted from the photocathode to allow making accurate measurements with a high signal to noise ratio even at very low light
levels. As a result of cooling, dark current reduces down to 1/50 at room
temperature after only 3 minutes of cooling.
Besides shorter cooling time and lower power consumption compared to
conventional methods that cool the entire photomultiplier tube, the H7844
completely eliminates the problem of condensation during cooling.
SPECIFICATIONS
Parameter
Anode
Cathode
Input Voltage
Max. Input Voltage for Main Unit
Max. Input Current for Main Unit
Max. Input Voltage for Thermoelectric Cooler
Max. Input Current for Thermoelectric Cooler
Max. Output Signal Current *1
Max. Control Voltage
Recommended Control Voltage Adjustment Range
Effective Area
Spectral Response Range
Peak Sensitivity Wavelength
Min.
Luminous Sensitivity
Typ.
Blue Sensitivity Index (CS 5-58) Typ.
Radiant Sensitivity *2
Typ.
Min.
Luminous Sensitivity *1
Typ.
Radiant Sensitivity *1 *2
Typ.
Gain *1
Typ.
Typ.
1
3
Dark Current * *
Max.
Equivalent Noise Input (ENI) *1 *2 *3
Rise Time *1
Max.
Ripple Noise *1 *4 (peak to peak)
Settling Time *5
Operating Ambient Temperature *6
Storage Temperature *6
Weight
Value
+11.5 to +15.5
+18
40
3.75
3.9
58
+1.2 (Input impedance: 100 kΩ)
+0.3 to +1.1
9 × 14
185 to 900
400
140
300
9.0
76
400
3000
7.6 × 105
1.0 × 107
0.1
0.5
2.4 × 10-17
2.2
0.5
0.2
+5 to +40
-20 to +50
290
(at 25 °C)
Unit
V
V
mA
V
A
µA
V
V
mm
nm
nm
µA/lm
—
mA/W
A/lm
A/W
—
nA
W
ns
mV
s
°C
°C
g
*1: Control voltage +1.0 V (PMT supply voltage -1000 V), with cooler operated
*2: At peak sensitivity wavelength
*3: After 30 minutes storage in darkness
*4: Signal cable RG-174/U, Cable length 450 mm, Load resistance 1 MΩ, Load capacitance 22 pF
*5: The time required for the output to reach a stable level following a change in the control voltage from +1.0 V to +0.5 V.
*6: No condensation
Subject to local technical requirements and regulations, availability of products included in this promotional material may vary. Please consult with our sales office.
Information furnished by HAMAMATSU is believed to be reliable. However, no responsibility is assumed for possible inaccuracies or omissions. Specifications are
subject to change without notice. No patent rights are granted to any of the circuits described herein. ©2005 Hamamatsu Photonics K.K.
PHOTOSENSOR MODULE
WITH THERMOELECTRIC COOLER H7844
COOLING SPECIFICATIONS
Description / Value
Thermoelectric cooling
20
Approx. 3
Parameter
Cooling Method
Max. Cooling Temperature (∆T) *7 *8
Cooling Time *7
*7: Input current to thermoelectric cooler = 2.1 A
Unit
—
°C
min
*8: Photocathode temperature difference from ambient
CHARACTERISTICS
●Spectral Response
● Anode dark current after cooling has started
(at 25 °C)
TPMOB0180EA
100
10
(at 25 °C)
TPMOB0181EA
10
ANODE DARK CURRENT (nA)
CATHODE RADIANT SENSITIVITY (mA/W)
QUANTUM EFFICIENCY (%)
CONTROL VOLTAGE: +1.0 V
(PMT SUPPLY VOLTAGE: -1000 V)
QUANTUM
EFFICIENCY
CATHODE
RADIANT
SENSITIVITY
1
0.1
1
0.1
0.01
0.01
100 200 300 400 500 600 700 800 900 1000
0
1
2
●Equivalent Noise Input (ENI)
●Gain vs. Control Voltage
(at 25 °C)
TPMOB0182EA
109
CONTROL VOLTAGE: +1.0 V
(PMT SUPPLY VOLTAGE: -1000 V)
BAND WIDTH: 1 Hz
WITH COOLER OPERATED
(at 25 °C)
TPMOB0183EA
WITH COOLER OPERATED
108
10-14
107
106
GAIN
EQUIVALENT NOISE INPUT (W)
5
4
TIME (min)
WAVELENGTH (nm)
10-13
3
10-15
105
104
10-16
103
10-17
200
300
400
500
600
700
800
WAVELENGTH (nm)
900
1000
102
0.3
0.4
0.5
0.6 0.7 0.8
1.0
CONTROL VOLTAGE (V)
1.2
1.5
SENSITIVITY ADJUSTMENT AND COOLING OPERATION
VOLTAGE PROGRAMMING
POWER SUPPLY for
COOLING FAN
+12 V
BNC-R
GND
COAXIAL CABLE (CURRENT OUTPUT)
THERMOELECTRIC COOLER (ORANGE)
GND (GREEN)
+3.2 V
2 A to 2.8 A
POWER SUPPLY
+11.5 V to
+15.5 V
GND
LOW VOLTAGE INPUT (RED)
GND (BLACK)
Vref OUTPUT +1.2 V (BLUE)
Vcont INPUT (WHITE)
GND
POWER SUPPLY for
THERMOELECTRIC COOLER
+0.3 V to
+1.1 V
GND
POWER SUPPLY for Vcont
• Adjust the control voltage when adjusting the anode sensitivity or gain of the PMT.
• Electrically isolate the reference voltage output. (This output is not used.)
• Low voltage input can also be used to supply the power to the cooling fan.
In this case, the low voltage input must be set to +12 V.
• Always run the cooling fan while the thermoelectric cooler is operating.
RESISTANCE PROGRAMMING
POWER SUPPLY for
COOLING FAN
+12 V
BNC-R
GND
COAXIAL CABLE (CURRENT OUTPUT)
THERMOELECTRIC COOLER (ORANGE)
GND (GREEN)
+3.2 V
2 A to 2.8 A
POWER SUPPLY
+11.5 V to
+15.5 V
GND
CW
LOW VOLTAGE INPUT (RED)
GND (BLACK)
Vref OUTPUT +1.2 V (BLUE)
Vcont INPUT (WHITE)
GND
POWER SUPPLY for
THERMOELECTRIC COOLER
• Monitor the control voltage when adjusting the anode sensitivity or
gain of the PMT with a trimmer potentiometer.
MONITOR
POTENTIOMETER (10 kΩ)
• We are currently developing a new integrated power supply that simultaneously supplies
power for the photomultiplier tube, thermoelectric cooler and cooling fan. Please contact
our sales office for more information.
TPMOC0189EA
PHOTOSENSOR MODULE
WITH THERMOELECTRIC COOLER H7844
DIMENSIONAL OUTLINE (Unit: mm)
CONNECTOR FOR COOLING FAN
48.0
44.5
COOLING
FAN *
21.0
52.0
6.8±0.3
* When installing the H7844 photosensor module,
be sure to allow enough space around the cooling fan for heat dissipation.
WINDOW
TOP VIEW
EFFECTIVE
AREA
(9 × 14)
PHOTOCATHODE
33.0
MOUNTING
THREADED HOLE
(2 × 4-M3 DEPTH 3)
7.7
RECEPTACLE FOR
THERMOELECTRIC COOLER
JST SLR-02VF L=60±10
8.0 15.5
23.0
87.0
77.0
33.5
2.6
106.0
51.2
7.4
30.6
5.0
9.0
20.0
20.0±0.3
POWER INPUT
HIROSE HR10A-7R-6P
1
6
2
38.0
MOUNTING
THREADED
HOLE
(4-M3 DEPTH 3)
32.0
FRONT VIEW
63.0
SIDE VIEW
SIGNAL
OUTPUT
BNC-R
REAR VIEW
5
3
4
1: GND
2: LOW VOLTAGE INPUT +15 V
3: Vcont +0.3 V to +1.1 V
4: Vref
5: GND
6: NC
Power cable with connector (HIROSE HR10A-7P-6S) is supplied with the H7844.
600 ± 20
42.0
BOTTOM VIEW
MOUNTING
THREADED
HOLE
(4-M3 DEPTH 10)
BLACK : GND
RED : LOW VOLTAGE INPUT (+11.5 to +15.5 V)
WHITE : Vcont INPUT (+0.3 V to +1.1 V)
BLUE : Vref OUTPUT (+1.2 V)
Thermoelectric cooler cable (AMP 179228-3) is supplied with the H7844
*Dimensional tolerance is
±0.5 mm unless otherwise specified.
GND : AWG18 (GREEN)
600 ± 20
THERMOELECTRIC COOLER
: AWG18 (ORANGE, +3.2 V, 2 A to 2.8 A)
Cooling fan lead wire (JST SLP-02V) is supplied with the H7844
FAN : AWG24 (RED, +12 V)
GND: AWG24 (BLACK)
600 ± 20
TPMOA0036EA
WEB SITE http://www.hamamatsu.com
HAMAMATSU PHOTONICS K.K., Electron Tube Division
314-5, Shimokanzo, Iwata City, Shizuoka Pref., 438-0193, Japan, Telephone: (81)539/62-5248, Fax: (81)539/62-2205
U.S.A.: Hamamatsu Corporation: 360 Foothill Road, P. O. Box 6910, Bridgewater. N.J. 08807-0910, U.S.A., Telephone: (1)908-231-0960, Fax: (1)908-231-1218 E-mail: [email protected]
Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49)8152-375-0, Fax: (49)8152-2658 E-mail: [email protected]
France: Hamamatsu Photonics France S.A.R.L.: 8, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: (33)1 69 53 71 00, Fax: (33)1 69 53 71 10 E-mail: [email protected]
United Kingdom: Hamamatsu Photonics UK Limited: 2 Howard Court, 10 Tewin Road Welwyn Garden City Hertfordshire AL7 1BW, United Kingdom, Telephone: 44-(0)1707-294888, Fax: 44(0)1707-325777 E-mail: [email protected]
North Europe: Hamamatsu Photonics Norden AB: Smidesvägen 12, SE-171-41 SOLNA, Sweden, Telephone: (46)8-509-031-00, Fax: (46)8-509-031-01 E-mail: [email protected]
Italy: Hamamatsu Photonics Italia: S.R.L.: Strada della Moia, 1/E, 20020 Arese, (Milano), Italy, Telephone: (39)02-935 81 733, Fax: (39)02-935 81 741 E-mail: [email protected]
TPMO1032E01
JUN. 2005. IP